Installation Instructions Otto Small Sphere Pendant Track Version 161305T A470 Page 1 of 8 CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.* Caution: Do not exceed maximum wattage noted on fixture.
A470 Installation Instructions Otto Small Sphere Pendant Track Version 161305T Page 2 of 8 Component Parts A Track Adaptors (2) B Supply/Support Cable C Fixture D Bulbs (2) (Not Included) E Glass Tube F Mesh Tube G Glass Globe Modern American Blacksmiths | Fine, Hand Crafted Lighting Castleton, Vermont USA | HUBBARDTONFORGE.
A470 Installation Instructions Otto Small Sphere Pendant Track Version 161305T Page 3 of 8 To Install Track Adapter (Figure 1) Caution: Be sure power is off at the main breaker box prior to installation 1. Carefully unpack the fixture (C) from the carton. 2. Determine desired finished height of fixture (C). 3. Using a sharp pair of cutters, cut the end of the supply/support cable (B) off square and clean at the desired length.
Installation Instructions Otto Small Sphere Pendant Track Version 161305T A470 Page 4 of 8 The product (luminaire) is intended to install on NRTL (UL, CSA, ETL, etc.) approved Edge Lighting Monorail System using Edge Lighting Fast Track connector model# FJ-MC-BZ.
A470 Installation Instructions Otto Small Sphere Pendant Track Version 161305T Page 5 of 8 To Install Glass (Figure 2) 1. Install bulbs (D) (not included). 2. Screw glass tube (E) in the socket cup until it stops. Note: you can screw the glass tube (E) into either socket cup to start. 3. While holding the glass tube (E) at an upward angle, slide the mesh tube (F) over the glass tube. 4.
A470 Installation Instructions Otto Small Sphere Pendant Track Version 161305T Page 6 of 8 Troubleshooting Guide: 12 Volt Pendant Lighting Part 1. For Hubbardton Forge Track Lighting products that use the “Fast Jack Male Coaxial Fixture Connector” from Edge Lighting, an Edge Lighting Installation Instruction “FJ-MC-_” is provided to the customer. This Instruction shows one method for installing coaxial cable into the coaxial fixture connector.
Installation Instructions Otto Small Sphere Pendant Track Version 161305T A470 Page 7 of 8 Note: The M3 Set Screw (F) must make electrical contact with the Coaxial Cable Inner Conductor (G), yet the instructions do not call for the inner conductor to be stripped back to expose the wire beneath. This is because the metal set screw pierces through the plastic insulation as the set screw is tightened to full torque.
Installation Instructions Otto Small Sphere Pendant Track Version 161305T A470 Page 8 of 8 Problem: Lights burn out quickly or burn very brightly: Diagnosis: Bad Socket Connection. Corrective action: Inspect Lamp Pins and socket contacts for evidence of discoloration. Replace if discolored. Diagnosis: Finger Oils on Quartz Lamps Corrective action: Wipe Glass clean with clean soft cloth on all Lamps after installation.
