Installation & Assembly

ASSEMBLY & INSTALLATION INSTRUCTIONS
Orion Single Pendants 136430 Medium & 136433 Large
A613
44706
To Install Fixture (Figures 1 & 2, next page)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY
OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be
installed in accordance with applicable installation code(s), by a person familiar with the construction and operation of
the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.
Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products.
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO INSTALLATION.
1. Carefully unpack xture (A) from the carton.
2. Thread the jam nut (D) and crossbar (B) onto threaded nipple (I). Leave parts loose. Threaded nipple is attached to
canopy pipe assembly (G).
3. Using two machine screws (not provided), temporarily fasten the crossbar (B) to the electric box.
Note: A new electric box comes with screws. When replacing a fixture, retain the existing screws for use with the new
fixture.
4. Adjust the length of the threaded nipple (I) in crossbar (B) so the canopy ring (F) will hold canopy (E) against the
ceiling with no threads showing for best appearance. When the correct adjustment is established, tighten jam nut (D)
against the crossbar to hold adjustment. Remove the crossbar (B) from the electrical box and proceed with assembly
instructions.
5. Locate fixture pipe (J) and slip it over the wires coming from fixture.
6. Apply a drop of the supplied thread locking compound to the internal threads of fixture coupling (H) and screw
fixture pipe (J) into fixture coupling, being careful not to twist the wires.
Note: Application of the thread locking compound is necessary to prevent the stem from loosening during
regular maintenance and cleaning of the fixture. Be certain to apply the compound.
7. Carefully slide canopy ring (F) and canopy (E) over xture pipe (J) until it rests on the xture. Make sure the smaller
diameter side of canopy ring is oriented up.
8. Slide the wires from the xture pipe (J) through the canopy pipe assembly (G).
9. Unscrew the clutch (K) from the canopy pipe assembly (G); slide it across the wires and onto the xture pipe (J).
Follow this with the plastic sleeve (M), oriented so the tapered end nests in the clutch (K) (Figure 2).
10. Slide the xture pipe (J) into the canopy pipe assembly (G) as far as necessary to give you the total length of the
xture which you desire. It may be necessary to loosen the set screw (L) in the clutch (K). Be careful not to scratch the
pipe surface and to pull excess wire up through the canopy pipe assembly (G). There must be a minimum 1-1/2" of
inner pipe inside the outer pipe.
11. Tighten the set screw (L) in clutch (K) rmly with hex wrench provided.
12. Using two machine screws (not provided), fasten the crossbar (B) to the electric box.
3 OF 4