Installation & Assembly

Modern American Blacksmiths | Fine, Hand-Crafted Lighting
Castleton, Vermont USA | HUBBARDTONFORGE.COM
39845
Assembly & Installation Instructions
If you need further assistance, or nd that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your xture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this xture.
B374
Orbit Sconce 209335
Page 4 of 4
H
G
I
K
J
F
A
E
LONG STUD
(Figure 2)
To Finish Installation (Figure 2)
1. Remove knurled ball (F) and cover plate (E). Retain for later use.
Note: Magnets are also used to hold cover plate (E) so a small amount of force will be needed to remove cover
plate (E).
2. Remove countersunk screws (H) along with countersunk plate (G) and retain for later use.
Note: Taking note of plate (G) alignment will aid in later installation.
3. Place glass (I) over LED (J) and press up against foam tape (K) on xture (A).
Note: Design preference is with textured side of glass (I) towards the wall.
4. Replace countersunk plate (G) onto xture (A) and install countersunk screws (H) to secure glass (I).
5. Align long stud in cover plate (E) with lower hole in xture (A). Press cover plate (E) tight to xture (A) until magnets
contact plate (E).
6. Secure cover plate (E) with knurled ball (F).
7. Restore electricity at main breaker.