Installation & Assembly

39845
Assembly & Installation Instructions
B374
Orbit Sconce 209335
MODERN AMERICAN BLACKSMITHS | FINE, HAND CRAFTED LIGHTING
CASTLETON, VERMONT USA | HUBBARDTONFORGE.COM
C
MACHINE SCREWS
D
A
B
Page 3 of 4
To Install Fixture (Figure 1)
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO INSTALLATION.
1. Carefully unpack the xture from the carton.
2. Using two machine screws (not provided) fasten the crossbar assembly (B) to the electric box with bent tabs facing
out.
Note: A new electric box comes with screws. When replacing a fixture, retain the existing screws for use with the
new fixture.
3. Hold xture (A) close to wall. Using suitable wire connectors (not provided) connect xture wires to supply wires
(white to white and black to black). Attach a pigtail lead to the crossbar ground screw (C). Connect all ground wires
(bare copper or green to bare copper or green). If ground screw (C) interferes with xture (A), move to a different hole
in the crossbar assembly (B).
4. Slide xture (A) over crossbar assembly (B) and push rmly to wall, making sure that no wires are pinched between
xture back and wall. Fasten with #8 screws (D) in top and bottom.
5. See instructions on next page to complete installation.
CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON SECURELY, AND NO BARE WIRES ARE EXPOSED.
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.
Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products and options.
(Figure 1)