Installation & Assembly

Installation Instructions A370
Quill Pendant 135001 Page 2 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 30901 -
8. Using suitable wire connectors (not provided) connect fixture
wires to supply wires (white to white, black to black). Run a
pigtail lead from crossbar ground screw (B) to the junction box
and connect all ground wires (bare copper or green to bare
copper or green). (Figure 1)
Caution: Make sure wire connectors are twisted on securely,
and no bare wire is exposed.
9. Raise canopy (D) close to ceiling. Align holes in canopy (D)
with holes in crossbar (A) and secure with (2) #8 screws (E).
10. If fixture needs to be lowered to achieve desired height, loosen
safety nut, push up on canopy gripper (G) and gently pull down
on supply/support cable (H). Retighten safety nut.
To Install Fixture Horizontally or Angled (Figure 3&4)
Component Parts
F Fixture
M Support Cable
N Anchor
O #6 Screw
P Cable Gripper
Note: This fixture maybe oriented vertically or horizontally or any angle in between.
1. Locate fourth decorative shield from canopy end of fixture. Remove hex head screw and gently move the
decorative shield to gain access to keyhole. Insert barrel end of cable (M) into large end of keyhole. Reattach
decorative shield with hex head screw. (Figure 3).
Caution: Do not leave decorative shield unsupported, by the wires.
2. Orient fixture to desired location
and determine appropriate
location for ceiling cable gripper
(P). With a pencil, mark this
location on the ceiling.
3. Drill 1/4" hole in the locations
marked on the ceiling. Place the
tapered end of the anchor (N)
into the hole and gently tap flush
to the wall using a light weight
hammer
4. Unscrew gripper base from cable
gripper (P). Slip #4 screw (O)
into gripper base and attach to
ceiling by screwing into anchor
(N).
5. Screw cable gripper (P) back on to gripper base. Insert support cable (M) into cable gripper. With the swivel
portion of the cable gripper oriented horizontally adjust support cable to correct height. Using heavy duty cable
cutters, cut excess support cable (M) short enough to allow swivel to rotate.
(continued)
(Figure 2)
(Figure 3)