Installation & Assembly

ManualsBrandsHubbardton Forge ManualsBlack Outdoor Hanging LightsHenry 1 -Light Outdoor Pendant

MODERN AMERICAN BLACKSMITHS | FINE, HAND CRAFTED LIGHTING

CASTLETON, VERMONT USA | HUBBARDTONFORGE.COM

45375

ASSEMBLY & INSTALLATION INSTRUCTIONS

A620

Henry Outdoor Pendant, Med 363008

3 OF 3

1. Carefully unpack xture (A) from the carton.

2. Slip xture pipe (B), threaded end rst, over xture wires.

3. Apply a drop of the supplied thread locking compound to the threads of the

xture pipe (B) and screw pipe into xture (A), being careful not to twist or pinch

the wires.

4. Slip wires from xture pipe (B) through canopy pipe assembly (E).

5. Slide canopy pipe assembly (E) down xture pipe (B) until desired xture height

is reached; tighten all 3 set screws (D) in clutch (C) evenly with hex wrench

provided to set the height.

6. Locate crossbar (F).Thread threaded studs (G) into appropriate locations that

align with the holes in the canopy pipe assembly (E). Threaded studs (G) should

be threaded into the same side of the crossbar (F) as the ground screw (H).

7. Using two machine screws (not provided), fasten the crossbar (F) to the electri-

cal box with threaded studs (G) pointing downward.

Note: A new electric box comes with screws. When replacing a fixture, retain the

existing screws for use with the new fixture.

8. Attach a pigtail lead to ground screw (H). Using suitable wire connectors (not

provided) connect wires to supply wires (white to white and black to black). Con-

nect all ground wires (bare copper or green to bare copper or green).

9. Slide canopy pipe assembly (E) over threaded studs (G) and push rmly to

ceiling. Fasten with knurled balls (I). Be sure studs (G) are fully seated in the

knurled balls (I).

10. Install gasket (J) onto bulb (K) (not Included), then install bulb into xture (A).

11. Restore electricity at main breaker.

Please Note: After installation extra hardware and accessories are possible due to our kits are used on multiple products and options.

To Install Fixture (Figure 1)

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND

PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with

applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.

Caution: Damp location outdoor hanging xtures are designed for use in covered spaces such as porches protected from prolonged

exposure to water and wind. If installing in locations subject to wind the use of supplementary chains, cables, or similar restraints

may be necessary to protect against swinging and twisting. If in doubt consult a qualied installer.

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO INSTALLATION.

(Figure 1)

MACHINE

SCREWS

CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON SECURELY AND

NO BARE WIRE IS EXPOSED.

CAUTION: BE SURE NO WIRES ARE PINCHED BETWEEN THE CANOPY AND

THE CEILING.

If you need further assistance, or nd that you are missing any parts, please contact the dealer from which you purchased this product. We hope you enjoy your xture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this xture.