Installation & Assembly

MODERN AMERICAN BLACKSMITHS | FINE, HAND CRAFTED LIGHTING
CASTLETON, VERMONT USA | HUBBARDTONFORGE.COM
42403
ASSEMBLY & INSTALLATION INSTRUCTIONS
Refraction Outdoor Sconces 302620 & 302623
B403
1. Carefully unpack the xture (A) from the carton.
2. Remove mounting bracket (E) from xture and set aside.
3. Remove lower set of thumb screws (C) and rubber washers (D). Loosen top set of thumb screws and rubber washers
but do not remove completely.
4. Slide front tube (B) upward and detach from xture (A). Set aside front tube (B) for later use (Figure 1).
See Figures 2 & 3 on next page for following instructions.
5. Using two machine screws (not provided) attach mounting bracket (E) to the electrical box.
Note: A new electric box comes with screws. When replacing a fixture, retain the existing screws for use with the new
fixture.
6. Using the green ground screw (F) and the cupped washer (G) in kit bag, secure a pigtail lead to the mounting
bracket (E).
To Attach to Wall (Figures 1 - 3)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.
Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products.
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO INSTALLATION.
CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED
ON SECURELY, AND NO BARE WIRES ARE EXPOSED.
D
C
B
A
E
(Figure 1)
3 OF 6
7. Hold the xture (A) close to the mounting bracket (E) and
using suitable wire connectors (not provided), connect
xture wires to supply wire (white to white and black to
black). Connect all ground wires (bare copper or green to
bare copper or green).
8. Apply a generous bead of a suitable caulking material
(not provided) to caulking lip (H) on the xture. Caulk
should be applied around the entire perimeter of the
backplate (Figure 3).
9. Carefully tuck all wires behind xture and inside the
mounting bracket (E). Place xture rmly onto bracket
and fasten with two #8 screws (I) and rubber washers (D)
on top.
Be sure Triangle plate is pointing upwards as seen in
Figure 2.
Note: Be sure no wires are pinched between wall and
fixture.
10. Install the two remaining #8 screws (I) in bottom of
xture.