Installation & Assembly

ASSEMBLY & INSTALLATION INSTRUCTIONS
Fritz Pendant Lg 188902
A612
44705
3 OF 5
To Install Fixture (Figures 1 & 2, next page)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY
OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be
installed in accordance with applicable installation code(s), by a person familiar with the construction and operation of
the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.
Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products.
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO INSTALLATION.
1. Carefully unpack xture (A) from the carton.
2. Thread jam nut (D) and crossbar (B) onto threaded nipple (I). Leave parts loose. Threaded nipple is attached to
canopy pipe assembly (G).
3. Using two machine screws (not provided), temporarily fasten crossbar (B) to the electric box.
Note: A new electric box comes with screws. When replacing a fixture, retain the existing screws for use with the new
fixture.
4. Adjust the length of the threaded nipple (I) in crossbar (B) so the canopy ring (F) will hold canopy (E) against the
ceiling with no threads showing for best appearance. When the correct adjustment is established, tighten jam nut (D)
against the crossbar to hold adjustment.
5. Remove the crossbar (B) from the electrical box and proceed with assembly instructions.
6. Locate fixture pipe (J) and slip it over the wires coming from fixture.
7. Apply a drop of the supplied thread locking compound to the internal threads of fixture coupling (H) and screw
fixture pipe (J) into fixture coupling, being careful not to twist the wires.
Note: Application of the thread locking compound is necessary to prevent the fixture pipe from loosening dur-
ing
regular maintenance and cleaning of the fixture. Be certain to apply the compound.
8. Carefully slide canopy ring (F) and canopy (E) over xture pipe (J) until it rests on the xture. Make sure the smaller
diameter side of canopy ring is oriented up.
9. Slide the wires from xture pipe (J) through canopy pipe assembly (G).
10. Unscrew clutch (K) from canopy pipe assembly (G); slide it across the wires and onto xture pipe (J).
Follow this with plastic sleeve (M), oriented so the tapered end nests in the clutch (K) (Figure 2).
11. Slide xture pipe (J) into canopy pipe assembly (G) as far as necessary to give you the total length of the xture which
you desire. It may be necessary to loosen set screw (L) in clutch (K). Be careful not to scratch the pipe surface and to
pull excess wire up through the canopy pipe assembly (G). There must be a minimum 1-1/2" of inner pipe inside the
outer pipe.
12. Tighten set screw (L) in clutch (K) rmly with hex wrench provided.
13. Using two machine screws (not provided), fasten crossbar (B) to the electric box.
continued...