Installation & Assembly

HUBBARDTONFORGE.COM

-, -   

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

31437-

Shade Installation Instructions

If you need further assistance, or nd that you are missing any parts, please contact the dealer from which you purchased this product.

We hope you enjoy your xture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this xture.

To Install Harp & Shade (Figure 1)

Component Parts

A Turn Knob

B Harp Holder

C Socket

D Locks (2)

E Harp

F Finial

G Shade

H Diffuser

I Washer

1. Carefully unpack the lamp from the carton.

2. Install turn knob (A) onto socket (C) (Figure 1).

3. Remove nial (F) and washer (I) from harp (E) and save for

later use. Finial and washer are shipped installed on harp.

4. Squeeze harp (E) together while holding the locks (D) up

towards the top of the harp (E) and slip into harp holder (B).

5. Allow locks (D) to slip down harp (E) and onto harp holder (B)

to secure harp in place.

6. Install bulb. Bulb is included with the “C” version.

7. Slip shade (G), diffuser (H) and washer (I) onto threaded stud

on top of harp (E). See Figure 3 for washer orientation.

8. Thread nial (F) onto threaded stud on harp (E) and tighten

until snug. Be careful not to over tighten.

C65

Helix Table Lamp 277770 & 277770C

Page 1 of 1

(Figure 1)

FINIAL

WASHER

TOP OF DIFFUSER

CORRECT ORIENTATION

WRONG ORIENTATION