Installation & Assembly

45268

ASSEMBLY & INSTALLATION INSTRUCTIONS

Dahlia Semi Flush 124350

A628

1. Carefully unpack the xture (A) from the carton.

2. Using two machine screws (not provided) attach

crossbar (B) to the electric box using outer oval holes

to orient xture.

Note: A new electric box comes with screws. When

replacing a fixture, retain the existing screws for use

with the new fixture.

3. Hold xture (A) close to ceiling. Using suitable wire

connectors (not provided) connect fixture wires to

supply (white to white and black to black). Attach a

pigtail lead to the crossbar using ground screw (C)

and cupped washer (D). Connect all ground wires

(bare copper or green to bare copper or green).

4. Carefully tuck all wires behind xture, push xture

rmly against the ceiling and fasten by threading

knobs (F) into stando󰀨s (E) on crossbar (B).

Note: Be sure no wires are pinched between th ceil-

ing and the fixture. Be sure threaded studs are fully

seated in knobs.

5. See instructions on next page for installing glass.

(Figure 1)

To Install Fixture (Figure 1)

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND

PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with

applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.

Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products.

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO INSTALLATION.

3 OF 4

CAUTION: MAKE SURE WIRE CONNECTORS ARE

TWISTED ON SECURELY, AND NO BARE WIRE IS

EXPOSED.

MACHINE

SCREWS