Installation & Assembly

MODERN AMERICAN BLACKSMITHS | FINE, HAND CRAFTED LIGHTING

CASTLETON, VERMONT USA | HUBBARDTONFORGE.COM

40137

ASSEMBLY & INSTALLATION INSTRUCTIONS

Cascade Pendant 139778

A518

continued

To Install Fixture - Figure 2

PAGE 5 OF 6

1. Locate the positive (+) and negative (-) labels on the top of the fixture (A).

2. Align the positive (+) and negative (-) labels on the fixture (A) with the positive (+) and negative (-) labels on

the grippers (K).

3. Slide a gripper (K) lock, small hole end first, onto supply/support cable (N). Repeat for remaining cables (N).

Locks are shipped in kit bag.

4. Push the supply/support cables (N) from the positive (+) sides of the fixture (A) into the grippers (K) with the

positive (+) labels. Push the cables (N) in far enough so that the cables (N) exit the side of the grippers (K).

5. Repeat step 3 for the negative (-) supply/support cables (N) & grippers (K).

6. Adjust fixture (A) to the desired height by pressing in the plunger on the grippers (K) and pushing/pulling the

supply/support cables (N) as necessary.

7. Once the fixture (A) is at the desired height cut the supply/support cables (N) as close to the notch in the

gripper (K) as possible.

8. Slide gripper (K) locks up the supply/support cables (N) and thread onto end of gripper (K) to lock adjustment.

LOCK

(Figure 2)

CAUTION: Once excess cable is cut, fixture cannot be lowered. Be sure that no piece of the supply/sup-

port cable is touching the fixture.