Installation Instruction

Assembly & Installation Instructions A365
Bento LED Pendant 138650D Page 3 of 6
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 30852
15. Thread cap (K) on to canopy nipple (I). Tighten against
canopy cover (J) until snug.
16. Refer to instructions following to assemble and install
shade.
Assemble Shade (Figure 6)
Component Parts
M Shade (6)
N Plastic Rivets.
1. Remove shade from plastic bag.
2. Locate ‘Flap End’ and “Open End” of shade. (Figure 6)
3. Secure “Flap End” of shade by pressing Plastic Rivets into holes in shade. (Figure 7 & 8)
4. Repeat steps 1-3 for all 6 shades.
5. Starting with two shades, place ‘Open end’ of one shade outside the ‘Flap End’ of the second shade.
(Figure 9) Secure two shades together in 3 places using plastic rivets. (Figure 10 & 11) Continue
attaching the additional shades until all are shades are attached. (Figure 12)
(Figure 5)
(Figure 6)