Installation Instruction

Assembly & Installation Instructions A365
Bento LED Pendant 138650D Page 2 of 6
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 30852
5. Loosen cable gripper locks before trying to install
cables. (Figure 3). Note: Support cable (F) will not be able
to pass through the cable gripper (G) unless the locks are
loose.
6. Raise fixture and push support cables (F) through the
canopy (C) and into the cable grippers (G) until desired
fixture height is accomplished and level. Once desired
height is accomplished and product is level, tighten
cable gripper locks. (Figure 3).
7. Using suitable wire connectors (not provided) connect
driver wires marked ‘supply’ to supply wires (white to
white, black to black). Connect all ground wires.
8. Push supply connectors up though the slot in the
insulating barrier so that connections are inside the
outlet box.
Caution: Make sure wire connectors are twisted on
securely, and no bare wire is exposed.
9. Locate the 4 PVC isolation sleeves (provided). Locate
support cable (F) with a (+) label on the fixture and slip
the 2 red isolation sleeves (provided) over the end.
Locate support cable (F) with a (-) label on the fixture
and slip the two black isolation sleeve (provided) over
the end.
10. Using heavy duty cable cutters, cut excess
supply/support
cable (F) allowing enough left (approx.3/ 4”) to make
connections.
11. Using suitable wire connectors (provided) connect
support cable (F) with red isolation sleeve to red driver
wire with (+) label attached. Connect support cable (F)
with black isolation sleeve to black driver wire with (-)
label attached. Caution: Make sure wire connectors are
on securely, and no bare wire is exposed.
12. Remove canopy support cable (D) by removing #8
screw (E) from ceiling bracket (A) and #8 nut from
canopy (C) (discard cable).
13. Raise the canopy (C) and attach to ceiling bracket (A)
with two flat head screws (H) (Figure 4).
14. Slip canopy cover (J) onto canopy nipple (I) (Figure 5,
next page).
(Figure 3)
(Figure 4)