Installation & Assembly

ManualsBrandsHubbardton Forge ManualsChandeliersArbo 3-Light Unique / Statement Drum Chandelier

If you need further assistance, or nd that you are missing any parts, please contact the dealer from which you purchased this product.

We hope you enjoy your xture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this xture.

HUBBARDTONFORGE.COM

-, -   

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

31538

Assembly & Installation Instructions

A374

For Arbo Pendant 136620

Page 2 of 2

(Continued)

(Figure 3)

To Complete Fixture Assembly (Figures 1 & 2)

6. Using suitable wire connectors (not provided) connect

xture wires to supply (white to white and black to black).

Run a pigtail lead from ground screw (D) to the junction box

and connect all ground wires (bare copper or green

to bare copper or green). Caution: Make sure wire connec-

tors are twisted on securely, and no bare wire is exposed.

7. Slide canopy (B) over threaded studs (E) and push rmly to

ceiling, making sure that no wires are pinched between

xture canopy and ceiling. Fasten with knurled balls (F). Be

sure studs (E) are fully seated in the knurled balls (F).

8. Once the xture is fastened to the ceiling, tighten the set

screw (J) in clutch (I) rmly with hex wrench provided. Only

after the set screw (J) is tight should you install the glass.

9. Refer to instructions following to install shade and diffuser.

To Install Shade & Diffuser (Figures 3 & 4)

Component Parts

K Fixture

L Shade

M Threaded Pipe

N Diffuser

O Flanged Washer

P Cap

1. Install bulbs (not included).

2. Remove anged washer (O) and cap (P) from threaded pipe

(M) and save for later use. Parts ship installed.

3. Rotate shade (L) around 3 arms of xture (K) and position

the shade (L) so it set level on the arms. (Figure 3)

4. Lift diffuser (N) up to washer on threaded pipe (M). Align

slots in diffuser (N) with arms on xture (K).

5. Slip anged washer (O) onto threaded pipe (M) and secure

diffuser (N) with cap (P). (be careful not to over tighten)

6. Restore electricity at the main breaker.

(Figure 4)

ARM