Manualshelf

Installation & Assembly

ManualsBrandsHubbardton Forge ManualsChandeliersArbo 3-Light Unique / Statement Drum Chandelier
12
HUBBARDTONFORGE.COM
-, -   
154 RT. 30 SOUTH
•
CASTLETON, VERMONT 05735
All designs and images ©1989-2014 Hubbardton Forge
®
. All rights reserved.
31538
Assembly & Installation Instructions
If you need further assistance, or nd that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your xture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this xture.
Pease Note: After installation extra hardware and accessories are
possible due to our kits are used on multiple products and options.
To Complete Fixture Assembly (Figures 1 & 2)
Component Parts
A Fixture Pipe
B Canopy
C Crossbar
D Ground Screw
E Threaded Stud (2)
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
1. Thread the wires from the xture pipe (A) into and through
the canopy pipe (G) up through the canopy (B).
2. Unscrew the clutch (I) from the xture pipe (A); slide it across
the wires and onto the canopy pipe (A). Follow this with the
plastic clutch sleeve (H), oriented so the tapered end of the
clutch sleeve nests in the clutch (Figure 1).
3. Slide the canopy pipe (G) as far as necessary to give you the
total length of the xture which you desire. Be careful not to
scratch the pipe surfaces and to pull excess wire up through
the canopy pipe (G). Screw clutch (I) onto xture pipe (A).
There must be a minimum 1-1/2" of inner pipe inside the
outer pipe. Hand-tighten the clutch to temporarily hold this
adjustment. The clutch is not securely fastened at this point;
do not depend on it to hold the xture.
Important: To ensure full connection strength, be sure the tapered
end of the plastic clutch sleeve is oriented toward the clutch when
assembled and securely tighten set screw (Figure 1).
4. Thread studs (E) through appropriate holes in crossbar (C) to match
holes in canopy (B).
5. Using two machine screws (not provided), fasten the crossbar (C)
to the electric box.
Note: A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
A374
For Arbo Pendant 136620
Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.
(Continued)
(Figure 2)
F Knurled Balls (2)
G Canopy Pipe
H Plastic Clutch Sleeve
I Clutch
J Set Screw
LARGE DIAMETER PIPE
TAPERED END OF
PLASTIC SLEEVE
(Figure 1)
C
E
D
B
F
G
J
I
H
A

Summary of content (2 pages)