Installation & Assembly

ASSEMBLY & INSTALLATION INSTRUCTIONS

Sprig Pendant 136420

A589

42408

4 OF 4

BULB

GROOVE

(Figure 2)

To Install Glass (Figures 2 & 3)

If you need further assistance, or nd that you are missing any parts, please contact the dealer from which you

purchased this product. We hope you enjoy your xture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of

this xture.

1. Unpack both sizes of glass (L & M).

2. Install bulbs (not included) into sockets (K).

See Figure 3 for placement of small & large glass.

3. Place glass (L/M) over the bulb.

4. Slide glass (L/M) into cup (N) until groove in glass lines up with thumb screws (O).

Note: Thumb screws are shipped in cups. It may be necessary to loosen thumb screws so glass can pass into cup.

Screws will not need to be removed completely.

5. Tighten thumb screws (O) evenly to secure glass.

6. Repeat steps for remaining glass.

7. Restore electricity at main breaker.

(Figure 3)