Installation & Assembly

ASSEMBLY & INSTALLATION INSTRUCTIONS

Sprig Pendant 136420

A589

42408

(Figure 1)

To Install Fixture (Figure 1)

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY

OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be

installed in accordance with applicable installation code(s), by a person familiar with the construction and operation of

the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.

Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products.

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO INSTALLATION.

3 OF 4

1. Carefully unpack xture from the carton.

2. Using two machine screws (not provided), fasten the crossbar (A) to

the electric box with the head of the ground screw (D) facing down.

Note: A new electric box comes with screws. When replacing a fixture,

retain the existing screws for use with the new fixture.

3. Thread nipple (C) into crossbar (A) and then thread lock nut (B) and

canopy loop (G) onto nipple (C), leaving parts loose. Adjust the length

of nipple in crossbar so that canopy ring (F), which comes threaded

onto canopy loop, will hold canopy (E) against the ceiling with no

threads showing for best appearance. When the correct adjustment is

established, tighten lock nut against crossbar to hold adjustment.

4. Remove the crossbar (A) assembly from electrical box.

5. Attach one end of the chain (H) to the xture loop (I) using a chain

spreader (not provided). Lace the wires through every other link of

the chain to the end. Slip wires and chain through canopy ring (F) and

canopy (E). Allow canopy ring and canopy to slide down chain and

rest on xture loop. Fasten the chain to the canopy loop (G).

6. Slip wires through the canopy loop (G) and nipple (C). Make sure to

provide enough slack in the wire to ensure weight of xture is

supported by the chain (H).

7. Using two machine screws (not provided), reattach the crossbar (A)

to the electric box.

8. Using suitable wire connectors (not provided) connect xture wires to

supply wires (white to ribbed side of the xture cord, black to smooth

side). Run a pigtail lead from crossbar ground screw (D) to the

junction box and connect all ground wires (bare copper or green to

bare copper or green).

9. Raise canopy (E) to the ceiling and secure loop collar (F) to canopy

loop (G).

10. Follow steps on next page to complete installation.

CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON

SECURELY AND NO BARE WIRE IS EXPOSED.