Installation Sheet

Assembly & Installation Instructions A433
Summer Pendant 139753D Page 3 of 4
Modern American Blacksmiths | Fine, Hand-Crafted Lighting
Castleton, Vermont USA | HUBBARDTONFORGE.COM 34942 Rev B
10. Screw barrel knobs with studs (K) into threaded
standoffs (J).
11. To completely secure canopy, thread #8 screws
(F) through canopy (B) and into mounting
brackets (A).
To Install LED Assembly (Figure 3)
Component Parts
I Supply Cable (4)
M LED Assembly
N Gripper (4)
O Gripper Cover (4)
1. Insert supply cable (I) through gripper cover (O) and into gripper (N) until cable (I) sticks through the
slot in the side of the gripper (N).
Note: Gripper covers (O) are shipped in kit bag.
2. Repeat with remaining cables (I).
3. Continue pulling cables (I) through grippers (N) until correct height is achieved. Be sure to keep LED
assembly (M) level.
Note: If fixture needs to be lowered, push down on top of gripper (N) to release cable.
4. Once desired height of the LED assembly (M) is achieved, cut off the excess cable (I) as close to the
gripper (N) as possible.
Caution: Once excess cable is cut, fixture cannot be lowered.
5. Screw gripper covers (O) onto grippers (N).
6. Follow instructions on following page to install decorative element.
(Figure 3)