Installation Sheet

Assembly & Installation Instructions A433
Summer Pendant 139753D Page 2 of 4
Modern American Blacksmiths | Fine, Hand-Crafted Lighting
Castleton, Vermont USA | HUBBARDTONFORGE.COM 34942 Rev B
4. Raise canopy (B) close to ceiling and attach safety cable (G) using safety cable nut (H) that is shipped
installed in the mounting bracket (A).
Note: Safety cable is used to temporarily suspend canopy while wiring connections are made.
5. Using cupped washers (D) and ground nuts (C) that ship installed on the mounting bracket (A), run
pigtail leads from both brackets to the outlet box. Connect all ground wires (bare copper or green to
bare copper or green). Push wires back into outlet box.
Caution: Make sure wire connectors are twisted on
securely, and no bare wire is exposed.
6. Using suitable wire connectors (not provided)
connect driver wires to supply wires (white to
white and black to black).
7. Slip supply cables (I) through appropriate
holes in canopy (B).
8. Remove barrel knobs w/ studs (K) from
threaded standoffs (J) as they are shipped
installed.
9. Raise canopy (B) and push firmly to ceiling,
making sure that no wires are pinched
between canopy (B) and ceiling.
(Figure 1)
(Figure 2)