Installation Sheet

Assembly & Installation Instructions A381
Erlenmeyer 4lt Semi-Flush 128710 Page 2 of 2
Modern American Blacksmiths | Fine, Hand-Crafted Lighting
Castleton, Vermont USA | HUBBARDTONFORGE.COM 32255 Rev A
5. Using suitable wire connectors (not provided) connect
fixture wires to supply (white to white and black to black).
Run a pigtail lead from the ground screw (F) to the
electrical box. Connect all ground wires (bare copper
or green to bare copper or green).
Caution: Make sure wire connectors are twisted on securely,
and no bare wire is exposed.
6. Thread nipple (G) in to threaded hole directly in center of
fixture mounting bracket (C).
7. Install cover (H) over nipple (G).
8. Thread cap (I) on to nipple (G) and tighten against cover (H)
until snug.
9. Refer instructions following to install glass.
To Install Glass (Figure 2)
Component Parts
A Fixture
J Socket (4)
K Glass (4)
L Thumb Screw (12)
1. Install light bulb (not provided) into socket
(J).
2. Loosen thumb screws (L). It is not
necessary to remove thumb screws (L).
3. Slip glass (K) into ring on fixture (A) aligning
groove in glass (K) with thumbscrews and
tighten thumbscrews (L) evenly.
4. Repeat with remaining glass (K).
5. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture
Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 2)