Installation Sheet

Installation Instructions A416
For 124422, 124422F, 124432, & 124432F Semi-Flush Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 33528
To Attach Support Rods to Canopy (Figure 1)
Components
A Canopy
B Support Rods (3)
C Knurled Ball (3)
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Carefully unpack the fixture from the carton.
2. Insert three support rods (B) through outer holes in canopy
(A).
3. Thread knurled ball (C) onto support rod (B) until snug
against inside of canopy (A).
To Install (Figure 2)
Components
A Canopy
D Crossbar
E Threaded Studs (2)
F Knurled Balls (2)
G Ground Screw
1. Thread studs (E) through appropriate holes in crossbar (D)
to match hole centers in canopy (A).
2. Using two machine screws (not provided) fasten crossbar
to the electric box using outer oval holes to orient fixture to
desired hanging position. Note: A new electric box comes with
screws. When replacing an existing fixture, retain the screws for
use with the new fixture.
5. Using suitable wire connectors connect fixture wires to
supply wires (white to white and black to black). Run a
pigtail lead from grounds screw (G) and connect all ground
wires.
Caution: Make sure wire connectors are twisted on securely,
and no bare wire is exposed.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
Figure 2