Installation & Assembly

ASSEMBLY & INSTALLATION INSTRUCTIONS

Gossamer Pendant, Large 139655

A649

45391

4 OF 6

To Install Fixture (continued) (Figure 4)

(Figure 4)

10. Thread the wires from the xture pipe (B) into

canopy pipe (G).

11. Slide canopy pipe (G) onto xture pipe (B) as

far as necessary to give you the total length

of the xture which you desire. Be careful

not to scratch the pipe surfaces and to pull

excess wire up through the canopy pipe

(G). Once desired height has been reached,

screw clutch (J) onto canopy pipe (G). There

must be a minimum 1-1/2" of inner pipe

inside the outer pipe. Tighten set screw (L) in

clutch rmly with hex wrench provided.

Note: To ensure full connection strength, be

sure the tapered end of the plastic sleeve

(K) is oriented toward the clutch (J) when

assembled and securely tighten set screw (L)

with provided hex wrench. (Figure 3)

12. Using wood screws (N), attach mounting

bracket (M) to a structural member in the ceiling,

centering the bracket over the outlet box.(Figure 5)

Wood screws are supplied with your xture; however, di󰀨erent

materials and/or construction methods may require di󰀨erent

fasteners. If in doubt, contact a qualied electrician. Do not attach bracket

directly to outlet box.

13. Raise canopy (I). Connect safety cable (O) from canopy(I) to mounting bracket (M)

using a #8 screw that ships in the mounting kit bag. Safety cable (O) is used to temporarily

suspend canopy while wiring connections are made.

14. Blue or black and red wires on drivers are shipped with connectors attached. Connect the red wires from

the drivers to the connector with the red wires from the xture and do the same for the blue wires. Blue to blue or

blue to black.

15. Using ground screw (Q) and cupped washer (P) that ship in mounting kit bag, run a pigtail lead from bracket to the

junction box. Connect all ground wires (bare copper or green to bare copper or green). Push wires back into outlet

box.

16. Using suitable wire connectors (not provided) connect driver wires to supply wires (white to white and black to black).

17. Raise canopy (I) and push rmly to ceiling, making sure that no wires are pinched between canopy (I) and ceiling.

Threaded studs (R) ship attached to barrel knobs (S). Screw studs (R) into bent bracket (F) to secure canopy (I).

18. Follow instructions on following page to install decorative assemblies.

CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON SECURELY AND NO BARE WIRE IS EXPOSED.