Installation & Assembly

ASSEMBLY & INSTALLATION INSTRUCTIONS

Gossamer Pendant, Large 139655

A649

45391

3 OF 6

To Install Fixture (Figures 1-3)

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY

OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be

installed in accordance with applicable installation code(s), by a person familiar with the construction and operation of

the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.

Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products.

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO INSTALLATION.

(Figure 1)

1. Carefully unpack xture (A) from the carton.

2. Carefully thread xture pipe (B), threaded end rst, over xture wires.

3. Apply a drop of supplied thread locking compound to the internal threads of

xture coupling (C) and screw xture pipe (B) into xture, being careful not

to twist the wires.

Note: Application of the thread locking compound is necessary to prevent

the stem from loosening during regular maintenance and cleaning of the

xture. Be certain to apply the compound.

4. Repeat steps 2 & 3 for remaining xture pipe (B)

5. Hex nipples (D) and lock washers (E) are shipped installed in swivels (H)

Remove these parts for use in next step.

6. Insert threaded end of hex nipple (D) down through lock washer (E), bent

bracket (F) and into swivel (H). (Figure 2)

7. Tighten securely being sure the notches in the swivels (H) are orientated

properly.

Note: If installing on a sloped ceiling, make certain that the notches in the

swivel portion of the stems are oriented toward the lower side of the slope.

8. Line up holes in canopy (I) with xture pipes (B). Slide over xture pipes (B)

until canopy (I) rests on top of xture (A). (Figure 4)

9. Unscrew clutch (J) from the canopy pipe (G); slide it across the wires

and onto xture pipe (B). Follow this with plastic sleeve (K), it may be

neccesary to loosed set screw (L). Repeat for second set of pipes.

Note: The sleeve should be oriented so the tapered end of the clutch

sleeve nests in the clutch. (Figure 3)

(Figure 2)

NOTCH

LARGE DIAMETER PIPE

TAPERED END

OF PLASTIC SLEEVE

(Figure 3)