Installation & Assembly

ASSEMBLY & INSTALLATION INSTRUCTIONS
Hildene Pendant 139651
A652
45396
5 OF 5
To Install Accents (Figure 3)
1. Locate accent pieces (P+Q), xture (M) will use two accent 2 (Q) and one accent 1 (P).
2. Install accents into xture (M).
Note: Point the tip of the triangle cutout in accent up to help orientation.
3. Once desired height of xture (M) with accents installed is achieved, cut o󰀨 excess supply/ support cable (D) as close
to slot in gripper (N) as possible.
4. Slide gripper covers (O) over grippers (N) and thread until snug.
5. Restore electricity at main breaker.
CAUTION: ONCE EXCESS CABLE IS CUT, FIXTURE CANNT BE LOWERED.
(Figure 3)
Q
P
Q
D
M
N
O
TRIANGLE
CUTOUT
TRIANGLE
CUTOUT
TRIANGLE
CUTOUT
If you need further assistance, or nd that you are missing any parts, please contact the dealer from which you
purchased this product. We hope you enjoy your xture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of
this xture.