Installation & Assembly

ASSEMBLY & INSTALLATION INSTRUCTIONS

Hildene Pendant 139651

A652

45396

4 OF 5

To Install Fixture (continued) (Figure 2)

1. Align end of xture (M) that has (+) and (-) labels with end of canopy (A) with (+) and (-) labels attached.

2. Unscrew gripper cover (O) from gripper (N). Slide gripper cover (O) over supply/support cable (D) with the small

hole rst. Insert cable (D) into gripper (N) until cable sticks through slot on side of gripper (N).

3. Repeat with remaining cables (D).

4. Adjust height of xture (M), making sure to keep xture level, by pulling on supply/support cables (D).

Note: If xture needs to be lowered, push down on top of gripper (N) to release cable.

Note: Excess cable will be cut after decorative assemblies are installed.

5. Follow instructions on next page to install decorative accents.

(Figure 2)

SLOT