Installation & Assembly

ASSEMBLY & INSTALLATION INSTRUCTIONS

Gossamer Pendant 139654

A651

45395

3 OF 5

To Install Fixture (Figures 1)

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY

OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be

installed in accordance with applicable installation code(s), by a person familiar with the construction and operation of

the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.

Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products.

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO INSTALLATION.

1. Carefully unpack xture (M) from carton.

2. Using #10 wood screws (C) attach mounting

bracket (B) to a structural member in the ceiling,

centering the bracket over the outlet box.

Note: Wood screws are supplied with your xture.

Dierent materials and/or construction methods

may require dierent fasteners. If in doubt,

contact a qualied electrician. Do not attach

bracket directly to outlet box.

3. Slide support cables (D) through holes in canopy

(A). Make sure to align (+) and (-) labels on

canopy (A) with (+) and (-) labels on mounting

bracket (B). Raise canopy (A) close to ceiling and

attach safety cable (K) using safety cable nut (L)

that is shipped on mounting bracket (B).

Note: Safety cable is used to temporarily

suspend canopy while wiring connections are

made.

4. Using suitable wire connectors (not provided)

connect driver (E) wires to supply wires (white to white and black to black).

5. Using cupped washer (F) and #8 nut (G) that are attached to bracket (B), attach a pigtail lead to the bracket.

Connect all ground wires together (bare copper or green to bare copper or green). Push wires back into outlet box.

6. Raise canopy (A) and push rmly to ceiling, making sure that no wires are pinched between canopy (A) and ceiling.

Screw barrel knobs (H) with threaded studs (J) into stando󰀨s (I) to secure canopy (A). (Barrel knobs (H) and

threaded studs (J) ship attached)

7. Follow instructions on following page to assemble xture.

(Figure 1)

CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON SECURELY AND NO BARE WIRE IS EXPOSED.