Installation & Assembly

45397
ASSEMBLY & INSTALLATION INSTRUCTIONS
Gossamer Sconce 207917
B451
3 OF 5
To Install Fixture (Figures 1 thru 3)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.
Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products.
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO INSTALLATION.
1. Carefully unpack xture (A) from the carton.
2. Remove mounting bracket (B) from xture (A).
3. Place mounting bracket (B) over the electrical box being sure to hold it level. Line up holes in mounting bracket with
holes in electrical box. With a pencil, mark the location of all mounting holes in the mounting bracket on the wall be-
hind. Set bracket aside.
4. Drill 1/4" holes in the locations marked on the wall. Place the tapered end of the anchors (C) into the holes and gently
tap them ush to the wall using a light weight hammer.
5. Thread the wires in the electrical box through the hole in the mounting bracket (B) while moving the bracket into
position. Using (2) #8 machine screws (not provided), attach the crossbar securely to the junction box.
Note: A new electric box comes with screws. When replacing an existing xture, retain screws for use with the new
xture
6. Using #10 screws (D), screw the bracket (B) securely to the wall. Be careful not to over-tighten or strip the anchors
(C)
7. Raise xture (A) close to wall and attach safety cable (H) using safety cable screw (I) that is shipped in the kit bag.
NOTE: Safety cable is used to temporarily suspend xture while wiring connections are made
8. Attach a pigtail lead to the mounting bracket (B) using the ground screw (E) and cupped washer (F) found in kit bag.
9. Hold xture (A) close to wall. Using suitable wire connectors (not provided), connect xture wires to supply wires
(white to white and black to black). Connect all ground wires (bare copper or green to bare copper or green).
10. Place xture (A) over mounting bracket (B). Secure with #8 screws (G) on top and bottom of xture.
NOTE: Be sure no wires are pinched between xture and wall.
11. Locate accent pieces. The xture comes with one of accent 1 (J) and two of accent 2 (K). (Figure 2)
12. Place accent 2 (K) and accent 1 (J) into appropriate holes in acrylic. (Figure 2) Note the location of the circle cutout
on accent 2 (K) to help orientation.
13. Restore electricity at main breaker.
CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON SECURELY, AND NO BARE WIRE IS EXPOSED.