Product Description

8
Chapter 4 Product Work Requirements
4.1 Power Requirements
The camera can choose to use 12V/2A switching power adapter or POE
power supply, the voltage parameters are shown in Table 4-1.
Table 4-1 Power supply voltage parameter table
Voltage requirements
power
DC12V (±10%)
Average: 7.0W
Maximum: 7.2W
Notice:
1. Using an incorrect power supply may damage the camera;
2. Do not use a power supply with a voltage greater than DC12V
(±10%);
3. The camera only supports the following three working modes, and
does not support working scenarios where both wired and
wireless are used at the same time:

(1)WI-FI connection network and DC12V power supply mode;
(2)POE power supply and wired network connection;

2) Wired network and DC12V power supply;
4.2 Storage and working environment requirements
Working temperature: 0°C~45°C;
Working humidity: 20~80%;
Storage temperature: -20°C~50°C;
Storage humidity: 20~80%;
Note: An effective cooling method must be provided to maintain a stable indoor
temperature. The following guidelines must be followed. In any case, monitor the
indoor temperature and ensure that the temperature does not exceed 50 °C. Fans
can be used for airflow cooling.
4.3 Camera Connector
The binocular passenger flow product leads out two connectors on the rear side,
which are DC JACK and Ethernet. The Ethernet interface is the data transmission
and POE power supply interface, and the DC JACK is the 12V power supply
interface.
Notice:
1. Using a power supply higher than 12V (±10%) will damage the product;
2. It is recommended to use standard POE power supply equipment, non-standard POE
power supply equipment will cause damage to the camera;