user manual
Table Of Contents
- 1 Getting to Know Your Device
- 2 Computer Requirements
- 3 Installation
- 4 Powering the Device On or Off
- 5 Registering the Handset
- 6 Setting Up a Wireless Connection
- 7 Accessing the Internet
- 8 Logging In to the Web Management Page
- 9 Using the Handset
- 10 Restoring Factory Defaults
- 11 FAQs
- The device does not work properly. What can I do?
- The handset will not power on. What can I do?
- No information is displayed on the handset screen. Why?
- The battery cannot be charged. What can I do?
- The handset continuously searches for the router. What can I do?
- The signal strength is weak. What can I do?
- The call volume is too high or too low. What can I do?
- 12 Safety Information
7
Skip this section if you do not need to connect an external
antenna to the router.
Before using an external antenna, log in to the web
management page (http://192.168.1.1) and set antenna mode
to outer. For details, see the help information on the web
management page.
Only use the external antenna indoors.
3.4 Installing the Handset Battery
1. Slide the battery cover off.
2. Insert the battery into the battery slot. Ensure that the golden contacts of
the battery mate securely with those in the battery slot.
3. Slide the battery cover back onto the handset.
If the handset will not be used for a long time, remove the battery
from the handset.
3.5 Connecting to a Computer
Use an Ethernet cable to connect a computer to one of the router's LAN
ports, as shown in the following figure.
When the connection between the router and the computer is set up, the
router's corresponding LAN indicator turns on.
Ensure that the Ethernet cable is not longer than 100 meters (328 feet).