Quick Start

ManualsBrandsHuawei ManualsMobile PhonesMate 10

Table Of Contents

Getting Started
- Follow the instructions in the following figures to set up your device.
- _
Dual card dual standby single pass (only applies to ALP-L29)
- Your device supports only dual card dual standby single pass, which means you cannot use both SIM cards for calls or data services simultaneously.lWhen you are on a call using SIM card 1, SIM card 2 cannot be used to make or answer calls. If someone calls SIM card 2, the caller will hear a voice message similar to "The subscriber you dialed is out of the service area" or "The subscriber you dialed cannot be connected for the moment, please try again later." The actual message will vary by service provider.lWhen you are using SIM card 1's data service, SIM card 2's data service will be disabled.Your device's single pass feature helps reduce power consumption and increase your device's standby time. It is not related to your service provider's network conditions.It may be a good idea to contact your service provider and subscribe to missed call reminder and related assistance services to avoid the conflicts mentioned above.
For more information
Safety Information
Legal Notice

Quick Start Guide

ALP-L09

ALP-L29

Summary of content (14 pages)

PAGE 1
Quick Start Guide ALP-L09 ALP-L29
PAGE 2
Your device at a glance Before you start, let's take a look at your new device. l l To power on your device, press and hold the power button until the screen turns on. To power off your device, press and hold the power button, and then touch .
PAGE 3
Getting Started OP 4 *. Follow the instructions in the following figures to set up your device. /B NJD SP4 % NJD SP4 % /B OP 4 *. /B OP 4 *. /B OP 4 *. ALP-L09 ALP-L29 Do not insert or remove the SIM card when your device is powered on. l Ensure that the card is correctly aligned and that the card tray is level when you insert it into your device. Be careful not to scratch your device or hurt yourself when using the eject pin.
PAGE 4
Dual card dual standby single pass (only applies to ALP-L29) Your device supports only dual card dual standby single pass, which means you cannot use both SIM cards for calls or data services simultaneously. l When you are on a call using SIM card 1, SIM card 2 cannot be used to make or answer calls.
PAGE 5
For more information If you encounter any problems while using your device, you can obtain help from the following resources: l l Visit http://consumer.huawei.com/en to view device information, frequently asked questions and other information. Visit http://consumer.huawei.com/en/support for the most up-to-date contact information for your country or region. Go to Settings and touch System > About phone > Legal to view legal information for your product.
PAGE 6
Safety Information Please read all of the safety information carefully before using your device to ensure its safe and proper operation and to learn how to dispose of your device properly. Operation and safety l l l l l l l l To prevent possible hearing damage, do not listen at high volume levels for long periods. Using an unapproved or incompatible power adapter, charger, or battery may damage your device, shorten its lifespan, or cause a fire, explosion, or other hazards.
PAGE 7
l l l l When charging the device, make sure the power adapter is plugged into a socket near the devices and is easily accessible. Unplug the charger from electrical outlets and the device when not in use. Do not use, store or transport the device where flammables or explosives are stored (in a gas station, oil depot, or chemical plant, for example). Using your device in these environments increases the risk of explosion or fire.
PAGE 8
Reduction of hazardous substances This device and its electrical accessories are compliant with local applicable rules on the restriction of the use of certain hazardous substances in electrical and electronic equipment, such as EU REACH, RoHS and Batteries (where included) regulations. For declarations of conformity about REACH and RoHS, please visit our web site http:// consumer.huawei.com/certification.
PAGE 9
Norway: This subsection does not apply for the geographical area within a radius of 20 km from the centre of Ny-Ålesund.
PAGE 10
ALP-L09 ALP-L29 GSM900: 37 dBm, GSM1800: 34 dBm, WCDMA900/ 2100: 25.7 dBm, LTE Band 1/3/7/8/20/28/34/38/40: 25.7 dBm, Wi-Fi 2.4G: 20 dBm, Bluetooth: 20 dBm, Wi-Fi 5G: 5150-5350 MHz: 23 dBm, 5470-5725 MHz: 30 dBm, NFC: 60 dBuA/m at 10m GSM900: 37 dBm, GSM1800: 34 dBm, WCDMA900/ 2100: 25.7 dBm, LTE Band 1/3/7/20/28/34/38/40: 25.7 dBm, Wi-Fi 2.
PAGE 11
The device complies with RF specifications when used near your ear or at a distance of 1.50 cm from your body. Ensure that the device accessories, such as a device case and device holster, are not composed of metal components. Keep the device away from your body to meet the distance requirement. Certification information (SAR) This device is also designed to meet the requirements for exposure to radio waves established by the Federal Communications Commission (USA). The SAR limit adopted by the USA is 1.
PAGE 12
--Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules.
PAGE 13
Legal Notice Trademarks and Permissions , , and are trademarks or registered trademarks of Huawei Technologies Co., Ltd. Android™ is a trademark of Google Inc. LTE is a trademark of ETSI. The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Huawei Technologies Co., Ltd. is under license. Wi-Fi®, the Wi-Fi CERTIFIED logo, and the Wi-Fi logo are trademarks of Wi-Fi Alliance.
PAGE 14
The N-Mark is a trademark or registered trademark of NFC Forum, Inc. in the United States and in other countries. Please visit http://consumer.huawei.com/en/support/hotline for recent updated hotline and email address in your country or region.