EVDO PC Embedded Datasheet

Product Datasheet
V001R006
Issue 2 (2009-01-20)
Confidencein Commercial
Page 49 of 60
TS212: UART1_DCD (DCD signal of the serial port 1)
TS303: UART3_RX (Rx signal of the serial port 3)
TS304: UART3_TX (Tx signal of the serial port 3)
TS213: PCM_CLK (PCM clock signal)
TS214: PCM_DOUT (PCM digital output signal)
TS215: PCM_DIN (PCM digital input signal)
TS216: PCM_SYNC (PCM synchronization signal)
TS402: UIM_PWR (power voltage signal of the UIM card)
TS403: UIM_RESET (UIM card reset signal)
TS404: UIM_CLK (UIM card clock signal)
TS405: UIM_DATA (UIM card data signal)
TS220: LED_WWAN (control signal of displaying the module state)
TS410: GND
By using the test points on the debugging board, you can test the key signals,
resistors, or test points on the module.
For EM660,there are severe Test points is reserved.
VI. Material List
Table 5-2 Material list
Item Part Number Quantity Description
PC - 1 It is provided by the
customer.
CMU200 - 1 It is provided by the
customer.
UIM card - 1 It is provided by the
customer.
Debugging board 03020NTP 1
USB cable 02450626 1 It is a 17 cm USB cable
used to connect the
USB-A connector to Mini
USB-B connector.
Antenna 27160038 1
RF cable 1 02450717 2 It is a 5 cm cable used to
connect the debugging
board to the module.