User's Manual

8
or press the power button. When the videoconferencing endpoint is powered on, it supplies
power to the camera to power the camera on.
Checking the Status Indicator
Steady green: The camera is working properly.
Steady yellow: The camera is in sleep mode.
Blinking green: The camera is upgrading.
Blinking red: The camera is faulty.
Controlling the Camera
The camera supports PTZ and lens control using an HD videoconferencing endpoint or remote
control.
To control the camera using an HD videoconferencing endpoint, connect the camera to the
videoconferencing endpoint using a serial cable. The maximum control length (cable length) is
50 m.
To control the camera using a remote control, set the infrared (RC) mode to IR-LOCAL or
RF-LOCAL.
Use the remote control to hide or display the On-Screen Display (OSD) configuration screen.
On the screen, you can perform image-related settings, for example, setting the image output
format and enable or disable the image inversion mode.
The following table describes the keys on the remote control, which are used to control the OSD
configuration screen.
Key
Description
Press it twice to hide or display the OSD configuration screen. (The
OSD configuration screen is displayed topmost.)
Press it to confirm an operation.
On the OSD configuration screen, press them to move to desired
options.