User's Manual

3
No.
Port
Description
videoconferencing endpoints.
9
Power port
Functions as a 12 V DC power input port.
10
SDI port
Functions as a bayonet-neill-concelman (BNC) connector to
output 3G-SDI and HD-SDI signals.
3G = 3rd Generation
HD = high definition
SDI = serial digital interface
11
VISCA IN port
Functions as a serial port to connect to an HD videoconferencing
endpoint or cascades to an upper-level camera. In addition, this
port can be used to upgrade the camera.
12
VISCA OUT
port
Cascades a lower-level camera. This port complies with the
Video System Control Architecture (VISCA) standard.
VISCA is a trademark of Sony Corporation.
13
HDMI OUT
port
Outputs HDMI2.0 signals and supports a resolution of up to
4K2Kp 60 fps.
14
HD-VI port
Inputs serial control signals, infrared signals, and 12 V power.
Outputs digital visual interface (DVI) or YPbPr video signals.
15
Network port
Performs operations such as camera upgrade as well as camera
angle adjustment (upward, downward, left, or right) and image
scaling (zoom in or out) through Telnet.
Installation
The VPC800 can be mounted on top of a display(such as TV set and monitor), wall-mounted,
ceiling-mounted, or placed horizontally, which you can select based on the site requirements.
If the displayis thicker than 170 mm or the display is wall-mounted, the VPC800 can be
installed in any possible way other than be mounted on top of the display.
If the display is 170 mm or thinner, the VPC800 can be mounted on top of a display or placed
horizontally.
Placed Horizontally
Place the camera on a flat surface.
If you have to place the camera on a sloping surface,
ensure that the slope is less than ±15° or the camera may
not function properly.
Mounted on Top of a Display
Use the L-shaped bracket and its accessories to secure the