User's Guide

HUAWEI TE30 Videoconferencing Endpoint
User Guide
6 Conference
Issue 01 (2013-03-27)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
53
Parameter
Description
Setting

Telepresence site: Select
this option for a Huawei
telepresence site.

CT site: Select this option
for a Cisco TelePresence
site.
Type
Specifies the line used for the site
to access the videoconferencing
network.

If you select IP, your TE30 will
use the protocol set for
Preferred IP protocol to call
the site.

If you set Category to CT site,
the available value for this
parameter is SIP.
The default value is H.323.
Number
Specifies the site number used to
place calls between sites.

The IP, E1, T1, 4E1, basic rate
interface (BRI), and H.323
phone site numbers are
allocated by the
videoconferencing service
provider.

The PSTN site numbers are
telephone numbers.
No default value is set for this
parameter.
IP address
Specifies the IP address of the site.
NOTE
This parameter is unavailable if you
set Category to IP address.
No default value is set for this
parameter.
Rate
Specifies the call rate of the line
selected for the remote endpoint.
The call rates supported vary
depending on the type of the site
you want to call.
The default value is 8Mbps.
Select the highest available
call rate.
URI
Specifies the uniform resource
identifier (URI) of the site, for
example, [e-mail].
NOTE
This parameter is available only when
Type is set to IP, H.323, or SIP.
No default value is set for this
parameter.
Country/Region
code
Specifies the country or area where
your TE30 is located.
This parameter is required when
Type is set to ISDN or PSTN.
No default value is set for this
parameter.