User's Guide

HUAWEI TE30 Videoconferencing Endpoint
User Guide
3 Network
Issue 01 (2013-03-27)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
24
3.7 Setting Network Diagnostics Parameters
Correct settings on the ports used for diagnostics enable you to use a network diagnostics tool
to diagnose your TE30 using the ports.
Procedure
Step 1 Choose Advanced Settings > Settings > Network > Diagnostics. Set the network
diagnostics parameters by referring to Table 3-7.y
Table 3-7 Network diagnostics parameters
Parameter
Description
Setting
Network
diagnostics
Specifies whether to enable the H.323
call port, RAS ports, and SIP call port to
be used for network diagnostics. If you
select this parameter, you must also set
H.323 call port, RAS source port, RAS
destination port, and SIP call port.
This parameter is deselected by
default.
H.323 call
port
Specifies the port the network
diagnostics tool uses to receive and send
call signaling during communication
with your TE30.
The default value is 1820.
RAS source
port
Specifies the port your TE30 uses to
receive and send RAS signaling during
communication with the network
diagnostics tool.
The default value is 1819.
RAS
destination
port
Specifies the port the network
diagnostics tool uses to receive and send
RAS signaling during communication
with your TE30.
The default value is 1819.
SIP call port
Specifies the port your TE30 uses to
send SIP signaling during
communication with the network
diagnostics tool.
The default value is 5160.
Test network
after exiting
conference
Specifies whether to perform the ping
operation after your TE30 exits a
conference. Ping results are recorded in a
log.
The default value is Enable.
Step 2 Select Save.
----End