User's Guide

HUAWEI TE30 Videoconferencing Endpoint
User Guide
3 Network
Issue 01 (2013-03-27)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13
Parameter
Description
Setting
Gateway
address
Specifies the gateway address that
corresponds to the IP address of your
TE30.
This parameter is mandatory when
Connection type is set to Static IP.
Contact the network
administrator.
Examples:

IPv4 address: 192.168.1.1

IPv6 address:
2000:0:0:0:200:55:0:1
Subnet
prefix length
Specifies the prefix length for the IPv6
address of your TE30.
The default value is 0.
Step 2 Select Save.
----End
3.2 Setting H.323 Parameters
When an H.323 network gatekeeper (GK) is used on your videoconferencing system, set the
H.323 parameters.
Prerequisites
A GK is used on the videoconferencing system.
Background
When a GK is used in the conference system, you can set the site number and name for your
TE30. Other endpoint also registered with the GK can then use the site number or name as
well as the IP address to call your TE30.
A GK is responsible for network bandwidth management, endpoint authentication, and address
translation on the videoconferencing system.
Procedure
Step 1 Choose Advanced Settings > Settings > Network > IP > H.323. Set the H.323 parameters
by referring to Table 3-2.
Table 3-2 H.323 parameters
Parameter
Description
Setting
Enable GK
Specifies whether to register your TE30
with the GK.

If you select this parameter, the TE30
will register with the GK after being
started. After the TE30 successfully
registers with the GK, it can call
endpoints defined in the address
This parameter is deselected by
default.