User's Guide

HUAWEI TE30 Videoconferencing Endpoint
User Guide
3 Network
Issue 01 (2013-03-27)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11
3.1 Setting IP Parameters
To use your TE30 on an IP network to implement video communication, correctly set IP
parameters, which include DNS server address, network interface mode, and gateway address.
Procedure
Step 1 Choose Advanced Settings > Settings > Network > IP > IP. Set the IP parameters by
referring to Table 3-1.
Table 3-1 IP parameters
Parameter
Description
Setting
IPv6
Specifies whether IPv6 is used. If you
use IPv6, you must also set Connection
type, Local IP address, Subnet prefix
length, and Gateway address.
This parameter is deselected by
default.
DNS server
address
Specifies the IP address of the active
Domain Name System (DNS) server.
After you set this parameter, domain
names can be used as the addresses of
network gatekeeper (GK) and Session
Initiation Protocol (SIP) servers. The
DNS server will translate the domain
names into the IP addresses of the GK
and SIP servers.
Example: 202.98.192.67
Alternate
DNS server
IP address
Specifies the IP address of the standby
DNS server. The standby DNS server is
used when the active DNS server is
unavailable or responds slowly.
Example: 202.98.198.167
Network
interface
mode
Specifies the working mode for the
network ports on your TE30.

Auto detection: When accessing the
network, your TE30 automatically
negotiates with a remote network
device to determine the optimal work
mode.

10 Mbps and half duplex: The data
transmission rate is 10 Mbit/s, and
data cannot be sent and received at
the same time.

10 Mbps and full duplex: The data
transmission rate is 10 Mbit/s, and
data can be sent and received at the
same time.

100 Mbps and half duplex: The data
transmission rate is 100 Mbit/s, and
data cannot be sent and received at
the same time.

100 Mbps and full duplex: The data
The default value is Auto
detection.
NOTE
If the remote network device you
wish to communicate with has its
network interface mode set to 10
Mbps and full duplex or 100
Mbps and full duplex, set this
parameter to be the same as the
remote network interface mode.
Otherwise, communication will
fail.