Quick Installation Guide

References for Installation

16/17 >>

Aligning an RTN 360

Install the alignment scope.

Adjust the azimuth and elevation of the RTN 360 by rotating the azimuth and

elevation adjustment nuts.

By rotating the elevation adjustment nut (nut

2), you can adjust the elevation of the RTN

360 from -50° to +50°.

By rotating azimuth

adjustment nut (nut 1),

you can adjust the

azimuth of the RTN

360 from -50° to

+50°.

Holes for installing

the alignment scope

Eyepiece

Lens

Adjust the azimuth and elevation of the local RTN 360 slowly to

move the crosshair of the alignment scope to the peer RTN 360.

Tighten the azimuth and elevation adjustment nuts.

Align the peer RTN 360 with the local RTN 360 in the

same way.

Remove the alignment scope.

Peer site

To adjust the azimuth and elevation of an RTN 360, rotate the

azimuth and elevation adjustment nuts. Do not attempt to turn

the device or mounting kits.

If the azimuth adjustment is insufficient to align the RTN 360

with its peer, loosen the hose clamp, re-position the RTN 360,

and then fasten the hose clamp.