Quick Installation Guide

Unscrew the azimuth
adjustment nut.
Hook the RTN 360 box (with the attachment plate
installed) to the fastener along the dowel.
Tighten the azimuth
adjustment nut using a hex key.
References for Installation
Optional: Installing an RTN 360 on a Pole
12/13 >>
Pass the hose clamps through the fastener and fix the hose
clamps on a pole using the screws of the hose clamps.
Install the RTN 360 box securely on the fastener.
Unscrew the azimuth
adjustment nut.
Hook the RTN 360 box (with the attachment plate
installed) to the fastener along the dowel.
Tighten the azimuth
adjustment nut using a hex key.
Optional: Installing an RTN 360 on a Wall
Press the fastener against a wall, level the installation location
using a level, and mark locating points using a marker.
Drill holes and install expansion bolts at the locating points.
Install the fastener onto the expansion bolts, place a flat washer, a
spring washer, and a nut on each expansion bolt, and then tighten
the nuts.
Ensure that each expansion bolt protrudes from 8
mm to 12 mm.
1. M6x60 bolt
2. Nut
3. Spring washer
4. Flat washer
5. Expansion sleeve
1. Fastener
2. RTN 360
Install the RTN 360 box securely on the fastener.
This side up
Before fixing the hose clamps, ensure that the
azimuth faces the peer site.