Quick Installation Guide

Installing an RTN 360
08/09 >>
Installing an RTN 360 at the Edge of a Mobile Backhaul Network
1
1
Installing an RTN 360 at the Edge of a Mobile Backhaul Network
Optional: Install the
RTN 360 on a pole.
Optional: Install the
RTN 360 on a wall.
External power
supply equipment
In this example, the RTN 360 uses port
P&E to receive services and power
signals.
1
1
2
3
6
6
Installation procedure
1
Install an RTN 360 on a pole or wall.
2
Install the ground cable.
3
Connect one end of an outdoor network cable to port
P&E on the RTN 360.
5
Connect the other end of the outdoor network cable to port WAN on a Dock.
To the RTN 360
To the opposite wireless equipment
Traffic transmitted to the opposite wireless
equipment is forwarded by port LAN0 on the Dock.
Use clips to fix any indoor sections of the outdoor
network cables that connect to ports WAN and
LAN0 on the Dock.
Clip
Commissioning procedure
6
Load commissioning data to the RTN 360 using the
Web LCT or USB flash drive.
Ensure that the received signal level (RSL) of
the RTN 360 meets the requirement.
7
8
Verify the installation.
PoE supports a maximum distance of 100 meters.
RTN 360
Dock
Optional: In this example, port GE(e) is
not used. In practice, determine whether
to use this port based on your service
plan.
Opposite wireless equipment
4
Align the RTN 360 with its peer.