Quick Installation Guide

External power
supply equipment
To the
RTN 360
To the opposite
wireless equipment
Clip
RTN 360
Dock
Opposite wireless equipment
Port WAN, which is connected to one RTN 360
Port LAN0, which is connected to the
opposite wireless equipment
Port LAN1, which is connected to the
other RTN 360
RTN 360
RTN 360
Dock
Opposite wireless equipment
External power
supply equipment
References for Installation
18/19 >>
Powering On an RTN 360
•After unpacking an RTN 360, power it on within 24 hours.
•Do not power off an RTN 360 for more than 24 hours during maintenance.
•Ensure that the Dock is powered on and works properly.
•On an RTN 360, only port P&E supports power over Ethernet.
If one Dock supplies power to only one RTN 360, connect the outdoor network cable that
connects to port P&E on the RTN 360 to port WAN on the Dock.
If one Dock supplies power to two RTN 360s, connect the outdoor network cable that connects to
port P&E on one RTN 360 to port WAN on the Dock, and the outdoor network cable that
connects to port P&E on the other RTN 360 to port LAN1 on the Dock.
STAT: is steady green.
When an RTN 360 is running properly, its indicators should be in the following states:
Use clips to fix any indoor sections of the outdoor network
cables that connect to ports WAN, LAN0, and LAN1 on the
Dock, and remove the plugs in the cable trough.