Installation Guide
Table Of Contents
- About This Document
- Contents
- 1 Changes in the DBS3900 (ICR) Installation Guide
- 2 Installation Preparations
- 3 Information to Be Known Before the Installation
- 4 Unpacking the Equipment
- 5 Obtaining the ESN
- 6 Installation Process
- 7 Assembling the IFS06
- 8 Installing the IFS06
- 9 Installing the Main Brackets for RRUs
- 10 Installing the GPS Surge Protector
- 11 Installing the IMB03
- 12 Installing the Equipotential Cable and PGND Cable
- 13 Installing Components in the IMB03
- 14 Installing RRUs
- 15 Installing Cables
- 15.1 Cabling Requirements
- 15.2 Cable Connections
- 15.3 Cable Installation Process
- 15.4 Cable Routes
- 15.5 Installing PGND Cables for RRUs
- 15.6 Installing the BBU Power Cable
- 15.7 Installing Input Power Cables
- 15.8 (Optional) Installing the DCDU Power Cable and Monitoring Signal Cable
- 15.9 Installing RRU Power Cables
- 15.10 (Optional) Installing BBU Inter-connection Cable
- 15.11 Installing Transmission Cables
- 15.12 Installing CPRI Optical Cables
- 15.13 Installing RF Jumpers
- 15.14 Installing the GPS Clock Signal Cable
- 16 Installation Checklist
- 17 Power-On Check
- 18 Installing the Cover Plate of the IMB03
Figure 15-12 Cable installation process
15.4 Cable Routes
This section describes the cable routes.
Figure 15-13 shows the planform of the cable tray. By studying the figure, you can know the
cable routes.
Figure 15-13 Cable routes
(1) -48 V DC or 220 V AC input
power cable
(2) Optical cables and PGND cables
for RRUs at the lower layer
(3) Feeders
(4) RRU power cables, E1/T1 cables,
and FE/GE Ethernet or optical cables
(5) +24 V DC input power cable -
DBS3900 (ICR)
Installation Guide 15 Installing Cables
Issue 12 (2015-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
120