F317 User Guide
1 Getting to know your F317 Front view The figures in this guide are provided for your reference only. 1 2 Left function key Access the main menu in standby mode. Navigation keys Access the main menu by pressing the OK key in Select the option displayed in the lower left corner of the screen. standby mode. Access a shortcut menu by pressing the corresponding navigation key in standby mode. Adjust the volume by pressing the navigation keys during a call.
Right function key Select the option displayed in the lower right corner of the screen. 4 Call key Make or answer a call. View the call log in standby mode. 5 End key End or reject a call. Press and hold this key to power the phone on or off. Return to the standby mode. 6 Hands-free key Make or answer a call without lifting the handset in standby mode. In the hands-free mode, cancel the dialing when dialing a number or end the current call.
Back and side view 7 6 5 4 3 1 2 1 Power jack 2 Battery cover 3 Coiled cord jack on main unit 4 SIM card slot 5 Battery container 6 Battery cord jack 7 Wall-mounting brackets 2 Screen icons Full reception Full battery Calling No service Alarm clock Hands-free mode Unread message Unopened voicemail message Powered by the power adapter 4
3 Installation Ensure that F317 is powered off and disconnected from the power adapter. Installing the SIM card Ensure that the golden contacts of the SIM card are facing downward and that the beveled edge of the SIM card is properly aligned with that of the SIM card slot. Then check that the SIM card is fully inserted. Do not frequently remove the SIM card when using F317. Installing the battery Ensure that the battery is correctly installed.
When new phones are delivered, the battery power is low. Therefore, charge the phone for a while and then power on the phone the first time you use it. If the phone will not be used for a long time, remove the battery from the phone. Connecting the power adapter When you use F317, it is recommended that you connect the power adapter to F317. If the battery has not been used for a long time or the battery is exhausted, the screen of F317 may not function when you charge the battery again.
2. Press to dial the number. 3. Press to end the call or cancel the dialing. You can also use the following methods to dial the number: In standby mode, press call log, and then press to view the call log. Find the desired number in the to dial the number. Find the desired number in the contacts, and then press to dial the number. Answering or rejecting a call When there is an incoming call, press the call. to answer the call; press 6 Messages Sending a message 1.
Press the left function key to manage the message. 7 Text input methods Input methods functions The input methods have following basic functions: In editing mode, press the # key to switch between input methods. In editing mode, you can press the right function key to delete the character to the left of the cursor or press and hold the right function key to delete all characters. In predictive and traditional input mode, press the 0 key to enter a space.
8 FM FM Radio helps you conveniently listen to the FM radio programs. Select Menu > FM radio, and then press / to switch the channel. Press adjust the volume. You can select Options for more operations. / to 9 Security Setting the phone lock The phone lock protects your phone from unauthorized use. If you enable phone lock, you will be prompted to enter a phone lock code before you use the phone. Select Settings > Security settings > Phone lock to set the phone lock.
card. PIN code and PUK code are provided together with the SIM card. For details, consult your service provider. 10 FAQs If problems occur during the use of the phone, refer to the following sections for a proper solution. If a problem persists, contact your phone vendor. What can I do if F317 cannot be powered on? 1. Remove the battery cover and check whether the battery is installed properly. 2. If the battery is properly installed, a possible cause for the problem is that the battery power is low.
For more help Please visit http://consumer.huawei.com/en/support/hotline for recently updated hotline and email address in your country or region. 12 Safety information This section contains important information about the operation of your device. It also contains information about how to use the device safely. Read this information carefully before using your device. Electronic device Do not use your device if using the device is prohibited.
When you must make or answer a call, pull off the road safely and park the vehicle first. RF signals may affect the electronic systems of motor vehicles. For more information, consult the vehicle manufacturer. Do not place the device over the air bag or in the air bag deployment area in a motor vehicle. Doing so may hurt you because of the strong force when the air bag inflates. Do not use your device while flying in an aircraft or immediately before boarding.
Do not block device openings. Reserve a minimum of 10 cm around the device to dissipate heat. Do not place sharp metal objects, such as pins, near the earpiece or speaker. The earpiece may attract these objects and result in injury. Stop using your device or applications for a while if the device is overheated. If skin is exposed to an overheated device for an extended period, low temperature burn symptoms, such as red spots and darker pigmentation, may occur.
Do not touch the power cord with wet hands or pull the power cord to disconnect the charger. Do not touch the device or the charger with wet hands. Doing so may lead to short circuits, malfunctions, or electric shocks. If your charger has been exposed to water, other liquids, or excessive moisture, take it to an authorized service center for inspection. Ensure that the charger meets the requirements of Clause 2.
protect it from collision. Keep the device and accessories dry. Do not attempt to dry it with an external heat source, such as a microwave oven or hair dryer. Do not expose your device or accessories to extreme heat or cold. These environments may interfere with proper function and may lead to fire or explosion. Avoid collision, which may lead to device malfunctions, overheating, fire, or explosion.
FCC Regulatory Compliance Body worn operation The device complies with RF specifications when used at a distance of 2.5 cm from your body. Ensure that the device accessories, such as a device case and device holster, are not composed of metal components. Keep the device away from your body to meet the distance requirement. Certification information (SAR) This device is also designed to meet the requirements for exposure to radio waves established by the Federal Communications Commission (USA).
13 Legal Notice Copyright © Huawei Technologies Co., Ltd. 2014. All rights reserved. No part of this manual may be reproduced or transmitted in any form or by any means without prior written consent of Huawei Technologies Co., Ltd. and its affiliates ("Huawei"). The product described in this manual may include copyrighted software of Huawei and possible licensors.
THE MAXIMUM LIABILITY (THIS LIMITATION SHALL NOT APPLY TO LIABILITY FOR PERSONAL INJURY TO THE EXTENT APPLICABLE LAW PROHIBITS SUCH A LIMITATION) OF HUAWEI ARISING FROM THE USE OF THE PRODUCT DESCRIBED IN THIS MANUAL SHALL BE LIMITED TO THE AMOUNT PAID BY CUSTOMERS FOR THE PURCHASE OF THIS PRODUCT.
