Packing List The FWT package box contains the following items. Check the items according to the following table. If any of the items is missing or damaged, contact your local dealer. Item Quantity Item Quantity Main unit, handset, and coiled cord 1 Battery 1 Power adapter 1 Antenna (optional) 1 FWT User Guide 1 Certificate of Quality 1 Front View of the FWT No.
No. 8 Item Function End key End or reject a call End the current operation when setting parameters Press and hold it to switch on/off the FWT Back View and Side View No. Item No. 2 Item 1 Antenna jack Power jack 3 Data port 4 Coiled cord jack on main unit 5 Battery container cover 6 Hook Screen Icons NO. Item Description 1 Indicates the signal strength. The more the bars are, the stronger the signal is. 2 Indicates that you are in the hands-free mode of the FWT.
NO. Item Description 8 Call duration Indicates the call duration of the current call. 9 Missed calls Indicates the number of missed calls. Installing UIM Card (Optional) Caution: y Whether an UIM card is needed, consult your service provider for details. y The UIM card and its golden contact can be easily damaged by scratch or bending. Thus, be careful when installing or removing the UIM card. After power off the FWT and disconnect the power, install or remove the UIM card.
Power off the FWT. Then connect the indoor antenna with the antenna jack on the main unit. Screw the antenna to make sure that the antenna is tightly connected with the antenna jack. Placing the FWT Horizontally Place the FWT on the flat surface. Select a cool and ventilated site to dissipate heat. Vertically 1. Pull out the handset retaining clip from the slot turn it around and then push it back so that the handset will not fall down when the FWT is placed vertically. 2.
Note: In the standby mode, if there is a missed call, the phone number of the missed call is displayed on the screen. At this time, you can press missed call. to dial the number of the Answering a Call In standby mode, you can lift the handset, press or press to answer a call. Note: y In standby mode, press to reject the incoming call. y Caller ID display function is network dependent. Consult your service provider.
3. 4. 5. 6. Press SET/OK key to display Code inputting interface. Enter the default password (0000) of the FWT. The screen displays the status (On or Off) of the long distance lock. Press ▲ or ▼ key until the screen displays On. Set the long distance lock function. If you want to disable this function, select Off. After setting, press SET/OK key. Make a Call When the Long Distance Lock Is Enabled When the long distance lock is enabled, adopt method 2. Follow these steps: 1.
Maintenance y y y y The FWT should be deployed in a clean and dry environment. A temperature higher than 55°C or lower than –10°C may damage the FWT. If the FWT is covered with dust, clean it with a clean fine cloth. Do not clean the FWT with cleanser or other chemical solvents. If the battery fails and causes problems of the FWT, replace it or use the power adapter. If the FWT does not work properly, consult your service provider.
Warnings and Precautions To use HUAWEI Fixed Wireless Terminal (FWT) correctly, efficiently and safely, you should notice following cautions. Basic Cautions y Check fittings based on the packing list to make sure they are complete and undamaged. y Read this manual carefully before installing and using FWT. Electronic Device Switch your FWT off near high-precision electronic devices. The FWT may affect the performance of these devices.
y y The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20cm from all persons. Please observe the national local regulations in the location where product is to be used. This product may be restricted for use in some or all countries of European Union. Emergency Call You can use your FWT for emergency calls. However, connections in all conditions cannot be guaranteed. You should never rely solely on the FWT for essential communications.
y y y y Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.
Huawei Technologies Co., Ltd. Address: Huawei Industrial Base, Bantian, Longgang, Shenzhen 518129, People's Republic of China Website: http://www.huawei.com Copyright © 2008 Huawei Technologies Co., Ltd. All Rights Reserved. No part of this manual may be reproduced or transmitted in any form or by any means without prior written consent of Huawei Technologies Co., Ltd. and HUAWEI are trademarks of Huawei Technologies Co., Ltd.
HUAWEI ETS2207 Fixed Wireless Terminal USER GUIDE Copyright © 2008 Huawei Technologies Co., Ltd. and other Huawei trademarks are the trademarks or registered trademarks of Huawei Technologies Co., Ltd. in the People’s Republic of China and certain other countries. All other trademarks mentioned in this manual are the property of their respective holders. The information in this manual is subject to change without notice.
E-mail: mobile@huawei.com Website: www.huawei.
