User's Manual

User Manual 4 Configuring the eSpace 6830
21
Table 4-3 Description of the basic setting page
Field Description
End User Password
This parameter allows changing the login password of an end
user.
This field is case sensitive with a maximum length of 30
characters.
IP Address The eSpace 6830 operates in two modes:
z DHCP/PPPoE Mode:
All the field values for the static IP mode are not
available even though they are stored in the Flash
memory. The eSpace 6830 acquires its IP address from
the first DHCP server that the eSpace 6830 detects on its
LAN. To use the PPPoE feature, set the PPPoE account.
The eSpace 6830 establishes a PPPoE session if any of
the PPPoE fields are set.
Host Name and Domain Name: The special DHCP
options that are added to the DHCP Discover and DHCP
Request after configuration.
Preferred DNS: The eSpace 6830 uses the DNS server if
Preferred DNS is configured
z Static IP Mode:
Configure all of the following fields: IP address, Subnet
Mask, Gateway, Default Router IP address, DNS
Server 1 (primary), and DNS Server 2 (secondary). The
fields are set to 0 by default except that the IP address is
set to 192.168.0.160 by default.
802.1X mode
This parameter is set to perform the 802.1X authentication
when the IP phone is connected to a switch. You can click
Disable to disable the authentication function, and click
EAP-MD5 to perform the registration authentication.
z Identify
ID used during the 802.1x authentication
z MD5 Password
MD5 password used during the 802.1X authentication
Iine Keys
This parameter is set for specifying function modes of line
keys. By default, the value of Key Mode is Line, which is
used by common lines. If the value of Key Mode is Shared
Line, it indicates that the BroadSoft SCA functions are
enabled and that accounts scattered in various areas can share
the line.