Copyright © 2009 Huawei Technologies Co., Ltd. All Rights Reserved No part of this document may be reproduced or transmitted in any form or by any means without prior written consent of Huawei Technologies Co., Ltd. Trademarks and Permissions Ltd. and other Huawei trademarks are trademarks of Huawei Technologies Co., All other trademarks and trade names mentioned in this document are the property of their respective holders. Notice The information in this document is subject to change without notice.
Table of Contents Getting to Know the EM770S ........................................................... 1 Requirements for the PC ................................................................. 2 Preparing the EM770S .................................................................... 3 Installation Guide .......................................................................... 4 Safety Information........................................................................
Thank you for purchasing Huawei EM770S HSPA Module. Note: This manual briefly describes the preparation, the process for installing/uninstalling, and safety precautions for using Huawei EM770S HSPA/Wi-Fi Module (hereinafter referred to as the EM770S). You are recommended to read the manual before using the EM770S. The signal strength and the transmission rate are affected by the actual environment. Getting to Know the EM770S The following figure shows the appearance of the EM770S.
Mini PCI Express connector It is used to connect the EM770S to the WWAN Mini PCI Express interface of the PC. Screw holes They are used to fix the EM770S on the main board of the PC with screws. Antenna interfaces They are used to connect antennas. EM770S has an external antenna which connect with laptop. The max gain which is allowed of external antenna is ： 900M:<2.1dBi 1800M:<2.6dBi 2100M:<4.3dBi 850M:<4.28dBi 1900M:<3.
Preparing the EM770S Locate the WWAN Mini PCI Express interface on the main board of the PC. Find the main antenna and the auxiliary antenna. If a USIM/SIM card is provided by your service provider, insert the USIM/SIM card into the USIM/SIM card slot on the main board of the PC. Note: In certain cases, your PC may be disassembled only by the professionals. Before you install the EM770S onto the main board of the PC, consult the PC manufacturer or read the user manual of the PC.
Installation Guide Installing the EM770S onto the Main Board of the PC 1. Insert the Mini PCI Express connector of the EM770S into the WWAN Mini PCI Express interface on the main board of the PC. 2. Press downwards to fix the EM770S in the module slot.
3. Use a screwdriver to fix the EM770S onto the main board of the PC with two screws provided in the EM770S packing box. 4. Insert the connector of the main antenna into the MAIN antenna interface (M) of the EM770S according to the indication on the label of the EM770S. Insert the connector of the auxiliary antenna into the AUX antenna interface (A) of the EM770S in the same way. Note: Insert the antenna connectors vertically into the antenna interfaces of the EM770S.
Do not pinch the antenna cable or damage the connectors. Otherwise, the wireless performance of the EM770S may be reduced or the EM770S cannot work normally. Ensure that the antenna cables are routed through the channel in the frame of the PC and do not lay across the raised edges of the frame.
Removing the EM770S from the Main Board of the PC 1. Disconnect the antenna cables from the EM770S. You can lift the connectors with a small screwdriver. 2. Remove the two screws with the screwdriver.
3. Slide backwards the two clips to release the EM770S from the slot. Then, lift up the EM770S. Installing the EM770S Software A disk is provided in the EM770S packing box. The disk contains the management program and the driver of the EM770S. 1. Insert the disk into the disk drive of the PC. 2. Find the AutoRun.exe file under the disk path. Then double-click AutoRun.exe to run the program. 3. Follow the prompts of the installation wizard. 4.
Note: It is recommended to restart the PC after the uninstallation to ensure that the management program is completely uninstalled.
Safety Information Read the safety information carefully to ensure the correct and safe use of your wireless device. Interference Do not use your wireless device if using the device is prohibited or when it causes danger or interference with electric devices. Medical Device Do not use your wireless device and follow the rules and regulations set forth by the hospitals and health care facilities. Some wireless devices may affect the performance of the hearing aids.
granule, dust, or metal powder) Area indicated with the "Explosives" sign Area indicated with the "Power off bi-direction wireless equipment" sign Area where you are generally suggested to stop the engine of a vehicle Traffic Security Observe local laws and regulations while using the wireless device. To prevent accidents, do not use your wireless device while driving. RF signals may affect electronic systems of motor vehicles. For more information, consult the vehicle manufacturer.
WEEE Approval The wireless device is in compliance with the essential requirements and other relevant provisions of the Waste Electrical and Electronic Equipment Directive 2002/96/EC (WEEE Directive). RoHS Approval The wireless device is in compliance with the restriction of the use of certain hazardous substances in electrical and electronic equipment Directive 2002/95/EC (RoHS Directive). Laws and Regulations Observance Observe laws and regulations when using your wireless device.
considerably low or high temperature. Use only accessories of the wireless device approved by the manufacture. Contact the authorized service center for any abnormity of the wireless device or accessories. Do not dismantle the wireless device or accessories. Otherwise, the wireless device and accessories are not covered by the warranty. Emergency Call This wireless device functions through receiving and transmitting radio signals. Therefore, the connection cannot be guaranteed in all conditions.
may cause undesired operation. Warning: Changes or modifications made to this equipment not expressly approved by HUAWEI may void the FCC authorization to operate this equipment.
