Copyright © 2007 Aweigh Technologies Co., Lid. All Rights Reserved No part of this manual may be reproduced or transmitted in any form or by any means without prior written consent of Aweigh Technologies Co., Lid. Trademarks awe and AWEIGH are trademarks of Aweigh Technologies Co., Ltd. All other trademarks mentioned in this manual are the property of their respective holders.
Table of Contents Getting to Know Your Data Card Preparation Installation Guide Warnings and Precautions Technical Specifications
Thank you for purchasing Aweigh EC360 E-DO data card. Aweigh EC360 is a wireless network card based on the CDMA2000 1x and CDMA2000 1XEV-DO Rev. A protocols, which can enable you to communicate from your laptop on COMA networks at a high speed with all the benefits of COMA technology. The EC360 provides data transmission Gambits, and supports receiving diversity. Mate: This manual briefs the profiles of Hummel EC360 E-DO data card, including the preparation, installation and installation process.
Preparation To use Aweigh EC360 E-DO data card, the following configurations for the laptop are required. « Equipped with Type Il PCMCIA soot and supporting CARD BUS. CPU: 133 MHz Pentium or above. 500 MHz Pentium or above is recommended. e Memory: 32 MB RAM or above. 128 MB or above is recommended. = Free space on the hard disk: 100 MB or above. = Windows XP, Windows 2000 or Window Vista is installed. » Resolution for the laptop screen: 800 x 600 or above. 1024 x 768 is rerecorded.
Installing the Hardware Driver 1. Insert the data card into the PCMCIA slot of the laptop. 2. The operating system (0S) detects and recognizes new hardware automatically and starts the installation Shield Wizard. Starting the Management Program = Double-click oH on the desktop to start the management program of the data card. Removing the Data Card Follow these steps strictly to remove the data card from your laptop. Otherwise, your system may be damaged, even the standby mode.
