Copyright © 2008 Huawei Technologies Co., Ltd. All Rights Reserved No part of this document may be reproduced or transmitted in any form or by any means without prior written consent of Huawei Technologies Co., Ltd. Trademarks and Permissions Ltd. and other Huawei trademarks are trademarks of Huawei Technologies Co., All other trademarks and trade names mentioned in this document are the property of their respective holders. Notice The information in this document is subject to change without notice.
Table of Contents Getting to Know Your E880...................................................................... 1 Requirements for the Computer ............................................................... 4 Preparation ........................................................................................... 4 Safety Information.................................................................................
Thank you for choosing Huawei E880 data card (hereinafter referred to as the E880). With the E880 data card, you can access the Internet through wireless network at a high speed. Note: This manual describes the appearance, installation and removal of the E880. For the operation of the management program, refer to the User Manual. Getting to Know Your E880 The following figure shows the appearance of the E880. It is only for your reference. The actual product may differ.
2 USIM/SIM Card Slot It is where you insert the user identity module (USIM/SIM) card. 3 Built-in Aerial Simply press the end and it will extend. We recommend you always have the aerial extended when connected to get optimum performance. When you have finished, push it back into the ExpressCard until it clicks. 4 Indicator It indicates the status of the E880. Colour Status Green Blinking (on for 100ms and off for 100ms; then on for 100ms and off for 2700ms) The E880 is powered on.
Green On The E880 is connected to a GPRS/EDGE network. Blue On The E880 is connected to a WCDMA network. Cyan On The E880 is connected to a HSPA network. - Off The E880 is removed.
Requirements for the Computer To use the E880, the computer must meet the following requirements: Equipped with ExpressCard slot. Windows 2000 SP4, Windows XP SP2, Windows Vista. Mac OS X 10.4 and 10.5 with latest upgrades Your computer’s hardware system should meet or exceed the recommended system requirements for the installed version of OS. Resolution for the display: 800 × 600 or above.
Installation/Removal Guide On different operating systems (OSs), the installation and removal procedures may differ. Follow the system prompts during operation. Connecting the E880 with a Computer 1. Pop up the Built-in Aerial. Simply press the end and it will extend. 2. Plug the E880 into the ExpressCard slot of a laptop. 3. Insert the supplied CD of the data card into the CD-ROM drive of the laptop. 4. The OS automatically detects and recognises new hardware and starts the installation wizard.
5. Follow the prompts of the installation wizard. 6. After the program is installed, a shortcut icon for the E880 management program is displayed on the desktop. Note: If the program does not respond, run the Setup.exe file in the CD drive path of the laptop. Starting the Management Program 1. Double-click the shortcut icon on the desktop to start the management program of the E880. 2. Enter the personal identity number (PIN) code if you have enabled the PIN lock. Removing the E880 1.
Note: Before removing the management program, exit the management program.
Safety Information Read the safety information carefully to ensure the correct and safe use of your wireless device. Interference Do not use your wireless device if using the device is prohibited or when it cause danger or interference with electric devices. Medical Device Do not use your wireless device and follow the rules and regulations set forth by the hospitals and health care facilities. Some wireless devices may affect the performance of the hearing aids.
Area where the air contains chemical substances and particles (such as granule, dust, or metal powder) Area indicated with the "Explosives" sign Area indicated with the "Power off bi-direction wireless equipment" sign Area where you are generally suggested to stop the engine of a vehicle Traffic Security Observe local laws and regulations while using the wireless device. To prevent accidents, do not use your wireless device while driving.
WEEE Approval The wireless device is in compliance with the essential requirements and other relevant provisions of the Waste Electrical and Electronic Equipment Directive 2002/96/EC (WEEE Directive). RoHS Approval The wireless device is in compliance with the restriction of the use of certain hazardous substances in electrical and electronic equipment Directive 2002/95/EC (RoHS Directive). Laws and Regulations Observance Observe laws and regulations when using your wireless device.
considerably low or high temperature. Use only accessories of the wireless device approved by the manufacture. Contact the authorized service center for any abnormity of the wireless device or accessories. Do not dismantle the wireless device or accessories. Otherwise, the wireless device and accessories are not covered by the warranty. Emergency Call This wireless device functions through receiving and transmitting radio signals. Therefore, the connection cannot be guaranteed in all conditions.
Body Worn Operation Important safety information regarding radiofrequency radiation (RF) exposure To ensure compliance with RF exposure guidelines the device must be used with a minimum of 1.0 cm separation from the body. Failure to observe these instructions could result in your RF exposure exceeding the relevant guideline limits. Regulatory Information The following approvals and notices apply in specific regions as noted.
.19 NOTICE: This device complies with Part 15 of the FCC Rules [and with RSS-210 of Industry Canada]. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 15.21 NOTICE: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. 15.
receiver is connected. • Consult the dealer or an experienced radio/TV technician for help.
