User's Manual

1
Thank you for choosing E220 HSDPA USB
Modem (hereinafter referred to as the E220)
from Huawei.
The E220 provides the following functions:
y Internet accessing
y Short messaging service (SMS)
y Contacts
Note: This manual briefly describes the basic
functions of the E220. For further
functions as well as warnings and
precautions, refer to User Manual.
Getting Started
1. Getting to Know the E220
The following figure shows the E220 profile.
USB interface
USIM/SIM card slot
Indicator
Note: The figure is for your reference only.
2. Indicator
This indicator indicates the status of E220.
y Off: The E220 is powered off.
y Green, Blinking twice every 2.7 seconds: The
E220 is searching for a network or no
network is available.
y Green, Blinking twice every 2.9 seconds: The
GSM network is normal.
y Blue, Blinking once every 2.9 seconds: The
WCDMA network is normal.
y Green: GPRS data service is established.
y Cyan: HSDPA data service is established.
y Blue: WCDMA data service is established.
3. Computer Configuration
Requirements
To use the E220, configure a computer
according to the following items:
y Central processing unit (CPU): Pentium 4, 1
GHz or above
y Memory: 128 MB RAM or above
y Hard disk: 50 MB or above
y Operating system (OS): Windows XP,
Windows 2000, or Windows Vista
y Universal serial bus (USB) modem interface:
USB 2.0 full speed
y Display resolution: 800 % 600 or above
(1024 % 768 is recommended)
2
Note:
y Improper configuration may degrade the
computer performance.
y For Windows XP, it is recommended to
install patches such as Service Pack 2 or
above.
y For Windows 2000, it is recommended to
install patches such as Service Pack 4 or
above.
Preparing E220
1) Remove the UMTS subscriber identity
module/subscriber identity module
(USIM/SIM) card slot from the E220.
Then insert the USIM/SIM card into the
card slot, as shown in the following
figure. Make sure that the USIM/SIM
card is fully in place.
2) Insert the card slot into the E220, as
shown in the following figure.
Installation Instructions
The installation procedures of the E220
Manager vary with operating systems (OSs).
Refer to the actual installation instructions
during the installation process.
1. Connecting the E220 with
a Computer
Note: First, power on a computer. Then
connect the E220 with the computer.
Otherwise, the normal installation of the
E220 can be affected.
The following figure is the sketch map of the
data cable.
Auxiliary USB
data cable
Mini-USB
data cable
Mini-USB
connector