Copyright © 2008 Huawei Technologies Co., Ltd. All Rights Reserved No part of this document may be reproduced or transmitted in any form or by any means without prior written consent of Huawei Technologies Co., Ltd. Trademarks and Permissions Ltd. and other Huawei trademarks are trademarks of Huawei Technologies Co., All other trademarks and trade names mentioned in this document are the property of their respective holders. Notice The information in this document is subject to change without notice.
Table of Contents What Is in Your Package ............................................. 1 Getting to Know Your E160 ......................................... 3 Preparation .............................................................. 6 Installation/Removal Guide ......................................... 8 Safety Information ...................................................
Acronyms and Abbreviations ......................................
Thank you for choosing Huawei E160 HSDPA USB Stick (hereinafter referred to as the E160). With the E160, you can access the Internet through wireless network at a high speed. Note: This manual describes the appearance, installation and removal of the E160. For the operation of the management program, refer to the User Manual.
One Quick Start One USB cable 2
Getting to Know Your E160 The following figure shows the appearance of the E160. It is only for your reference. The actual product may differ. 1 2 3 6 4 5 n USB Interface It connects the E160 to a computer.
o SIM/USIM Card Slot It is where you insert the subscriber identity module/UMTS subscriber identity module (SIM/USIM) card. p Micro SD Card Slot It is where you insert the Micro Secure Digital Memory (SD) card q External Antenna Jack It connects the E160 to an external antenna. r Strap Hole s Indicator It indicates the status of the E160.
- Off network. The E160 is removed.
Preparation Requirements for the Computer To use the E160, the computer should meet the following requirements: USB Type A Receptacle, Compatible with USB 2. 0 High Speed. Windows 2000 SP4, Windows XP SP2, Windows Vista. Your computer’s hardware system should meet or exceed the recommended system requirements for the installed version of OS. Resolution for the display: 800 × 600 or above. Getting Your E160 Ready Remove the USIM/SIM card slot from the E160.
Inserting the Micro SD Card (Optional) Insert the micro SD card into the E160, as shown in the following figure. Note: Do not remove the micro SD card when it is being used. Removing the card during an operation may damage the micro SD card as well as the device, and data stored on the card may be corrupted.
Installation/Removal Guide On different operating systems (OSs), the installation and removal procedures may differ. Follow the system prompts during operation. Connecting the E160 with a Computer Note: First, power on the computer. Then connect the E160 with the computer. Otherwise, the E160 cannot be installed as normal. Plug the E160 into the USB interface of the laptop or desktop computer. You can connect the E160 to a laptop or desktop computer using the USB cable for better signals.
The OS automatically detects and recognises new hardware and starts the installation wizard. Follow the prompts of the installation wizard. After the program is installed, a shortcut icon for the E160 management program is displayed on the desktop. Starting the Management Program After the E160 is installed, the management program is launched automatically. Then every time the E160 is connected to the PC, the management program is launched automatically.
Removing the Management Program Click Start Menu. Click Control Panel. Click Add/Remove Program to remove the management program of the E160. Note: Before removing the management program, exit the management program.
Safety Information Read the safety information carefully to ensure the correct and safe use of your wireless device. Interference Do not use your wireless device if using the device is prohibited or when it cause danger or interference with electric devices. Medical Device Do not use your wireless device and follow the rules and regulations set forth by the hospitals and health care facilities. Some wireless devices may affect the performance of the hearing aids.
Area where the air contains chemical substances and particles (such as granule, dust, or metal powder) Area indicated with the "Explosives" sign Area indicated with the "Power off bi-direction wireless equipment" sign Area where you are generally suggested to stop the engine of a vehicle Traffic Security Observe local laws and regulations while using the wireless device. To prevent accidents, do not use your wireless device while driving.
WEEE Approval The wireless device is in compliance with the essential requirements and other relevant provisions of the Waste Electrical and Electronic Equipment Directive 2002/96/EC (WEEE Directive). RoHS Approval The wireless device is in compliance with the restriction of the use of certain hazardous substances in electrical and electronic equipment Directive 2002/95/EC (RoHS Directive). Laws and Regulations Observance Observe laws and regulations when using your wireless device.
Do not leave your wireless device and accessories in a place with a considerably low or high temperature. Use only accessories of the wireless device approved by the manufacture. Contact the authorized service center for any abnormity of the wireless device or accessories. Do not dismantle the wireless device or accessories. Otherwise, the wireless device and accessories are not covered by the warranty. Emergency Call This wireless device functions through receiving and transmitting radio signals.
Failure to observe these instructions could result in your RF exposure exceeding the relevant guideline limits. Regulatory Information The following approvals and notices apply in specific regions as noted. CE Approval (European Union) The wireless device is approved to be used in the member states of the EU. The wireless device is in compliance with the essential requirements and other relevant provisions of the Radio and Telecommunications Terminal Equipment Directive 1999/5/EC (R&TTE Directive).
Canada]. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operati NOTICE: Changes or modifications made to this equipment not expressly approved by (manufacturer name) may void the FCC authorization to operate this equipment.
· Consult the dealer or an experienced radio/TV technician for help. CAUTION: The USB Stick has been tested with specific integral antenna for SAR compliance with three notebook computers having vertical and horizontal USB slots. The device can be used in notebook computers with substantially similar physical dimensions, construction, and electrical and RF characteristics.
SAR SIM UMTS USB USIM WCDMA Specific Absorption Rate Subscriber Identity Module Universal Mobile Telecommunications System Universal Serial Bus UMTS Subscriber Identity Module Wideband Code Division Multiple Access Version: V100R001_01 Part Number: 31018914 18
